Submersible Pump Toothpick Pen 1Hp Ideal Pump For Collecting Water From Artesian Wells For Supplying Water Tanks, Pump Must Contain Power Of 1Hp (750W), Voltage (N) 220V Three-Phase, Flow Rate (Q) 4,800 L/H, Height (Hm) 95 Mca, Connection (Pol) 1.1/4, Submersion (Hs) 80M, Stage (N) 9, Width 10 Cm, Length 82 Cm, Weight 12Kg, Submersible Pump Stick Pen 1.1/2Hp, Ideal Pump For Collecting Water From Artesian Wells For Supplying Water Tanks, Pump Must Contain Power Of 1.1/2Hp (1100W), Height (Hm) 135 Mca, Stage (N) 12, Length 96 Cm, Weight 14.5 Kg., Submersible Pump Of 9 Hp, Ideal Pump For Water Collection In Deep Wells, Widely Used In Water Tank Supply Systems, Pump Must Contain Coupling Key System, Radial Flow Rotor, Outlet Nozzle 2 With Bsp Thread, Flow 6 A 14 M³/H, Manometric Height 15 To 382 M.C.A, Power Of 9 Hp, 14 Stages, Three-Phase, 220V, 160 Cm High By 15 Cm Wide, 10 Hp Submerged Motor Pump, Coupled To A Water Lubricated Electric Motor Designed To Operate Under Water At Great Depths, Motorpump Must Contain, Coupling By Key System, Radial Flow Rotor, 1 ¹/² Outlet Nozzle With Bsp Thread, Flow 3.6 To 9 M³/H, Manometric Height 166 To 308 M.C.A, Power Of 10Hp, 22 Stage, Three-Phase, 191.5 Cm Height By 14, 7 Wide, 15Hp Submersible Motor Pump, 2 ¹/² Outlet Nozzle With Bsp Thread, Flow 12 To 24 M³/H, Manometric Height 104 To 201 M.C.A, Power Of 15Hp, 14 Stage, 205, 9 Cm Height By 14, 12/19/2025 - 13:01:45, Peripheral Pump 1/2Hp Two-Phase, 220V Peripheral Pump Must Contain 1/2Hp (370W), Flow 1,800L/H, 22 M.C.A, Suction (Hs) 8M, Connection 1 Bsp, 14 Cm Wide, 16.3 Height, And 28 Cm In Length, Weight Of 3.7, Three-Phase 25 Hp Motor Pump And A Monobloc Horizontal Centrifugal Motor Pump Designed To Pump Clean Or Cloudy Liquids, Motor Pump Must Contain 25 Hp Power, 220 V Voltage, 212 Mm Impeller, Snail, Rotor, Pressure Cap And Bearing In Gg-25 Cast Iron, Stainless Steel Mechanical Seal, Motor Electric Ip-55, 2 Or 4 Poles 60 Hz, Back Pull-Out System For Easy Maintenance, Motor Pump 5 Hp, Single-Phase 220 V, With Capacitor, Motor Pump Must Contain Stainless Steel Shaft, Closed Rotor Made Of Aluminum Or Bronze, Mechanical Seal Made Of Stainless Steel, Inlet Side, Output Body Division And Cast Iron Intermediate, Motor Electric Ip-21 2 Poles 60Hz (Up To 3Hp), Electric Motor Ip-55 2 Poles 60Hz (From 4Hp)
