Bids Are Invited For Rp Acquisition Of School Furniture With Installation, Assembly And Delivery...

Dining Room Set With Childrens Back Dining Room Set With Childrens Backs Description- Dining Room Set Consisting Of 1 (One) Table And 2 (Two) Stackable Benches. Tubular.Constituents- Top And Seats In Mdp, 25 Mm Thick, Covered On The Upper Face In High Pressure Melaminicode Laminate, 0.8 Mm Thick, Frost Finish, In White. Coating On The Lower Face In Low Pressure Melamine Laminate - Bp, Frost Finish, In White. Drilling And Placement Of Zamac Bushings, Self-Tapping, 1/4 Internal Thread, 13 Mm Long. Finished Dimensions: - Top: 1500 Mm (Width) X 700 Mm (Depth) X 640 Mm (Height) - Seat: 1350 Mm (Width) 380M (Height) - Tops Headed With Extruded Thermoplastic Maple Tape, Made Of Pvc (Polyvinyl Chloride); Pp (Polypropylene) Or Pe (Polyethylene), With Primer On The Bonding Face, Textured Surface Finish, In Red Color, Glued With Hot Melt Adhesive. Minimum Tear Strength Of E70n. Nominal Dimensions Of 29Mm (Width) In Sae 1008 Carbon Steel Tube, Cold Rolled, With Seam, Diameter 38 Mm (1 1/2), In Plate 16 (1.5Mm);- Longitudinal Cross In Sae1008 Carbon Steel Tube, Cold Rolled With Seam, Square Section 40Mm Cross Beams In Sae 1008 Carbon Steel Tube, Rectangular Section 20Mm X 50Mm, 5 Mm. Sae 1008 Carbon Steel Sheet, In Plate 14 (1.9Mm), Printed.-Fixing The Top/Seat To The Structures Through:, Childrens Dining Room Set Dining Room Set Consisting Of 1 (One) Table And 2 (Two) Stackable Benches. Table With Mdp Top, Mounted On Tubular Structure. Benches With Mdp Seats, Covered In Laminated Laminate, Mounted On A Tubular Structure.Constituents- Top And Seats In Mdp, Covered On The Upper Face In Low Pressure Melamine Laminate - Bp, In White (See References). Drilling And Placement Of Bushings In Zamac, Self-Tapping, 13 Mm In Length.- Finished Dimensions:- Top: 1500 Mm (Width) (Polyethylene), Glued With Hotmelt Adhesive. Minimum Tear Resistance Of 70N (See Manufacture). Nominal Dimensions Of 29Mm (Width) 50Mm, 5Mm).- Structural And Fixing Supports For The Top/Seat Made Of Sae 1008 Carbon Steel Sheet, Stamped According To The Project.- Top Fixing Fins Made Of Sae 1008 Carbon Steel Sheet, Stamped.-Fixing Of The Top/Seat To The Structures Using:- Thread Screws 1/4 X 2 1/2 Inch Machine, Flat Head, Single Slot