Tenders Are Invited For Electrical Installation Appointment Prof. Steiner

Type Of Servicethe Construction Project Includes The Conversion Of Laboratory Rooms At The Pharmaceutical Institute Of The University Of Münster, In Component A On The Kg Level And In Component C, Ground Floor Level And 1St Floor Level. It Should Be Noted That The Laboratories Will Not Be Completely Opened Up For The Measure, Existing Facilities Are Available. The Following Rooms Are Part Of The Measure: Room A. 090.009 New Storage Room To Be Created Below The Stairs. This Area Will Be Separated From The Stairwell And Will Receive A New Supply Line For The New Lighting. The Door With Free-Swing Function Also Receives A New Supply Line. Led Fr Lights Are Provided On Site For Lighting. The Installation Is Surface-Mounted.Room C.100.034 Conversion Into A Cip Seminar Room, Adaptation Of The Installation, Renewal Of The Lighting/Safety Lighting, Dismantling Of The Emergency Stop Circuit In The Room And In The Distribution Room C.100.035 Conversion Into A Dissolution Laboratory, Adapting The Installation To The New Use, Setting Up A New Laboratory Distribution, Renewing And Supplementing The Lighting/Safety Lighting, Cabling Laboratory Rows And Equipment, Adapting The Blind Control (Knx) Room C.100.036 Laboratory Renewal Of The Lighting / Safety Lighting Room C.100.037/038 Conversion Of 2 Rooms Into A Laboratory Room, Remove The Installation For The Removal Of The Partition Wall, Adapt The Installation To The New Use, Set Up A New Laboratory Distribution, Renew And Supplement The Lighting / Safety Lighting, Wire Laboratory Lines And Equipment, Adapt The Blind Control (Knx) Room C.110.164 Research Laboratory, Renovation Lighting / Safety Lighting Safety Lighting: The Building Has A Central Battery System (Zb-S From The Manufacturer Ceag (Eaton)) With Sub-Centres. The General Room Lights Are Sometimes Used As Security Lights. For This Purpose, The Corresponding Lights Receive A Corresponding Light Module. So That The Lights Can Be Used Both For General Lighting And As Emergency Lights, A Corresponding Bus Module Is Installed In The Existing Distributions. This Component Is Also Used In The New Distributions. These Blocks Must Be Integrated Into The Corresponding Bus. All Distribution And Lighting Modules Must Be Configured According To The New Requirements.