Bids Are Invited For Hiring A Company To Execute Works Under A Global Contract Regime For Execution Of Reform And Expansion Works Next To The Arduino Pedro Parise Basic Health Unit, With The Use Of Resources From The Government Of The State Of Rio Grande Do Sul (Ses Ordinance No. 962/2025) And Own.

Lot 1 - Supply And Installation Of Workplate With Galvanized Sheet And Wooden Structure. Af_03/2022_Ps, Lot 1 - Mechanized Trench Excavation With Prof. Greater Than 1.5 M Up To 3.0 M (Average Upstream And Downstream/One Composition Per Section), Backexcavation. (0.26 M3), Width From 0.8 M To 1.5 M, On 1St Category Soil, In Locations With High Level Of Interference. Af_09/2024, Lot 1 - Mechanized Trench Embankment With Hydraulic Excavator (Bucket Capacity: 0.8 M³ / Power: 111 Hp), Width Up To 2, Depth From 1.5 To 3.0 M, With Clay-Sandy Soil. Af_08/2023, Lot 1 - Removal Of Doors, Manually, Without Reuse. Af_09/2023, Lot 1 - Removal Of Cold Water Pipes (Tubes And Connections), 11/10/2025 - 10:33:58, Lot 1 - Conventional Work Location, Using Template Of Pointed Running Boards Every 2.00M - 2 Uses. Af_03/2024, Lot 1 - Manual Excavation For Crowning Block Or Footing (Including Excavation For Placing Formwork). Af_01/2024, Lot 1 - Ballast With Granular Material, Application In Crowning Blocks, Thickness Of *5 Cm*. Af_01/2024, Lot 1 - Block Frame Using 10 Mm Ca-50 Steel - Assembly. Af_01/2024, Lot 1 - Block Frame Using 5 Mm Ca-60 Steel - Assembly. Af_01/2024, Lot 1 - Concreting Footing, Fck 30 Mpa, Using Pump - Laying, Densifying And Finishing. Af_01/2024, Lot 1 - Manufacture, Assembly And Disassembly Of Formwork For Baldrame Beam, In Sawn Wood, E=25 Mm, 2 Uses. Af_01/2024, Lot 1 - Surface Waterproofing With Cement Mortar And Sand, With Waterproofing Additive, E = 1.5Cm. Af_09/2023, Lot 1 - Concreting Of Crowning Block Or Baldrame Beam, Lot 1 - Manufacture Of Formwork For Pillars And Similar Structures, In Resin Plywood Sheet, E = 17 Mm. Af_09/2020, Lot 1 - Pillar Or Beam Frame Of Conventional Reinforced Concrete Structure Using 10.0 Mm Ca-50 Steel - Assembly. Af_06/2022, Lot 1 - Framing Of Miscellaneous Reinforced Concrete Structures, Except Beams, Pillars, Slabs And Foundations, Using 5 Ca-60 Steel, Lot 1 - Concreting Of Pillars, Fck = 25 Mpa, Densification And Finishing. Af_02/2022_Ps, Lot 1 - Manual Embankment Of Trenches With Clay-Sandy Soil. Af_08/2023, Applied To Floors Or Slabs On Ground, Lot 1 - Slim Concrete Ballast, Applied To Floors, Slabs On Ground Or Radiers, Thickness Of 3 Cm. Af_01/2024, Lot 1 - Subfloor In Mortar Mix 1:4 (Cement And Sand), Mechanical Preparation With A 400 L Concrete Mixer, Applied In Dry Areas On Slabs, Not Adhered, Non-Reinforced Finish, Thickness 4Cm. Af_07/2021, Lot 1 - Manufacture Of Formwork For Beams, Lot 1 - Pillar Frame Or Beam Of Conventional Reinforced Concrete Structure Using Steel Ca-60 Of 5, Lot 1 - Concrete Fck = 20Mpa, Ratio 1:2, 7:3 (In Dry Mass Of Cement/Medium Sand/Gravel 1) - Mechanical Preparation With Concrete Mixer 400 L. Af_05/2021, Lot 1 - Unidirectional Precast Slab, Double-Supported, For Lining, Ceramic Filling, Conventional Joist, Total Slab Height Lt = 12 Cm (Filling+Cover) = (8+4). Af_08/2025, Lot 1 - Pillar Or Beam Frame Of Conventional Reinforced Concrete Structure Using Ca-50 Steel Of 8, Lot 1 - Concreting Of Beams And Slabs, Fck=25 Mpa, For Slabs, Lot 1 - Sealing Masonry Of Horizontally Drilled Ceramic Blocks Of 9X19x19 Cm (Thickness 9 Cm) And Laying Mortar Prepared In A Concrete Mixer. Af_12/2021, Lot 1 - In-Situ Cast Concrete Yard, Thickness *20* Cm. Af_03/2024, Lot 1 -