Rental, Installation, Maintenance And Uninstallation Of Light Emitting Diodes (Led), In Blue Color, In Single Uniformity, Static, With Spacing Between Light Emitting Diodes (Led) Of 9.0 To 10.0Cm Maximum, *Seamless*, For External Use Ip44, With Protection Cover For The Connection Of The Wires Between Light Emitting Diodes (Led), In Order To Prevent Water Entry With Two Terminals, One At Each End, With 01 (One) Male Connector And 01 (One) Female Connector, With Thread And Guide For Correct Connection. The Connection Cable Must Be 50Cm Long, From The Power Supply To The Start Of The Voltage Stabilization Module Must Be Up To 30Cm With ±2%, The Voltage Stabilization Module Must Be 5Cm Long With ±2%, And From The Receiving Part To The Start Of The Voltage Stabilization Module 15Cm With ±2%. Wire Thickness 1.8Mm With ±3%; The Led Must Be 4Mm With ±2%. The Electrical Cables That Connect The Diodes (Leds) Must Be Covered With Appropriate Synthetic Material, In Green, To Avoid Vandalism And Provide A Better Visual Appearance During The Day. Voltage 220 Volts, Minimum Power Of 3 Watts And Maximum Of 4Watts. The Light Emitting Diodes (Led), Will Be Used To Decorate Trees, And The Distance When Installing Christmas Lights, On The Trees, Should Be 2.0Cm To 2.5Cm Between The Strings, Maintenance And Uninstallation Of Light Emitting Diodes (Led), In Red Color, Static With Strobe Lamp Every 04 Diodes And Spacing Between Them 9 Light Emitting Diodes (Led), In Order To Prevent Water Entry, With Two Terminals, With Thread And Guide For Correct Connection. The Connection Cable Must Be From The Output Of The Light-Emitting Diode To The “Male” Connection Terminal Of The “Source” Voltage Stabilization Module Power Connection Of At Least 1.05 Meters, The “Source” Voltage Power-Up Module Must Support A Maximum Of 300 Light-Emitting Diodes (Leds). Wire Thickness Of 1, To Avoid Vandalism And Provide A Better Visual Appearance During The Day, Voltage 31 Volts, Minimum Power Of 5 Watts And Maximum Power Of 10 Watts. The Distance When Installing Light-Emitting Diodes (Leds) Must Be A Maximum Of 10 Cm Between Cords. (Three) Phases In Measurements Of 50Cm, 65Cm And 45Cm, May Vary ± 5%, With M/F Connector With A Maximum Length Of 10 Meters, Wire Thickness Of 1.5Mm With Diode (Led) Of 4Mm And With A Distance Between The Diodes Of 9 To 10Cm, Minimum Power Of 5 Watts And Maximum Power Of 15 Watts, Green Wire. For Asymmetrical Measurements, The 03 Phases Do Not Need To Follow The Order Above, And Can Start From The Largest To The Smallest Or Vice Versa, Used For Decoration Of The Central Pergola., Maintenance And Uninstallation Of 2X2 Circular Pp Flex Cable, 50Mm², 300/500Volts, With A Maximum Temperature Of 70ºdegreesc, As Per Nbrnm247-5. Labor For Decorating Trees And Pergolas Located In The Central Square Of Santa Bárbara D’Oeste (Praça Coronel Luiz Alves And Praça Rio Branco), And Trees Located In Praça Nove De Julho, Including Installation, Maintenance And Uninstallation, Including Temporary Use Materials, Equipment And Labor., Maintenance And Uninstallation Of Ornaments - Estrela Snowfall 10 Points, In The Geometric Shape Of A Decagonal Star (10 Points), Incorporated With Snowfall Tubes, Simulating
