Tenders Are Invited For Transformation Of The Former Pkp Facility For The Needs Of The Municipal Utility Company In Małomice

The Subject Of The Order Includes: The Subject Of The Order Is The Replacement Of A Residential And Service Building Located In Małomice At Ul. Dworcowa 1, Plot No. 135/12, District 0001, Registration Unit 081005_4 Małomice, Damaged Felt Roof Covering, Covered With Gray Or Graphite Coated Sheet Metal, Thickness. 0.50 Mm For Standing Seam. The Roof Covering Should Be Laid On A Formwork Made Of 19-25 Mm Boards (The Task Includes Replacing Approx. 20% Of The Existing Formwork - Damaged), On Which The Initial Covering Membrane Should Be Placed. By Performing, Among Others, The Following Works: - Dismantling The Roofing Made Of Felt Paper On Overlapping Formwork, With Nailing Of The Slope - 438.66 M2; - Dismantling Gutters, Downpipes, Flashings Of Eaves, Collars And Chimneys Made Of Unusable Sheet Metal; - Manual Dismantling Of Free-Standing Chimneys Using Wedges And Hammers; - Re-Building Of Chimneys. Multi-Flue Free-Standing Chimneys Made Of Bricks With A Duct Cross-Section - Brickwork From The Attic Floor, With Cleanout Holes For Each Opening, Faced With Clinker Bricks, With Mounting Handles For Entry To Chimney Benches, - Making Windows And Hatches; - Replacing The Damaged Roof Formwork With 19-25 Mm Thick Boards (As The Existing Ones) With Butt Joints In The Damaged Areas; - Laying The Initial Covering Membrane Laid On The Formwork - Fastened To The Boards With Staples Or Temporarily With Patches; - Flashing Of Eaves Made Of Coated Sheet Metal; - Sheet Metal Processing For Baskets Made Of Coated Sheet Metal; - Sheet Metal Flashing Of Chimneys Made Of Coated Sheet Metal; - Roof Covering With Gray Or Graphite Coated Sheet Metal, 0.50 Mm Thick; Spacing Of The Perpendicular Hem Is Approximately 50-70 Cm Per Area. 438.66 M2; - Construction Of Semi-Circular Roof Gutters With A Diameter Of 15 Cm - Assembly From Ready-Made Elements Made Of Coated Steel Sheet; - Execution Of Round Downpipes With A Diameter Of 12.5 Cm - Assembly From Ready-Made Elements Made Of Coated Steel Sheet; - Construction Of A Chimney Sweep Bench; - Construction Of A Lightning Protection System; - Waste Management; In Accordance With The Attached Technical Description Prepared By The Designer, Mrs. Ewa Milewska Mrożek, And The Attached Bill Of Quantities.4.3. The Bills Of Quantities Attached To The Swz Are Only Of Auxiliary Nature And Cannot Constitute The Only Basis For The Valuation Of The Offer. The Contractor Is Obliged To Carefully Check And Estimate The Amount Of Required Works Against The Design Documentation. Due To The Fact That The Contract For The Works In Question Will Include A Lump Sum Remuneration, In The Event Of A Larger Quantity Of Specific Works Included In The Project In Any Bill Of Quantities Item During The Works, It Cannot Be Considered Additional Works Requiring Additional Remuneration. Any Lack Of Necessary Works Resulting From The Design Documentation In The Bill Of Quantities Does Not Release The Contractor From The Obligation To Perform Them Based On The