Tenders Are Invited For Long-Term Rental (36 Months) Of A Truck With A Garbage Truck Body

The Subject Of The Order Is The Rental For A Period Of 36 Months Of A Single-Bucket Garbage Truck On A 3-Axle Chassis Intended For Collecting Solid Waste Collected In Municipal Containers, Recyclable Raw Materials And Large-Sized Waste, With A Purchase Option. Construction Parameters: 1. Development Not Older Than 2024.2. Box Body With Rear Loading Device, Intended For Collecting Solid Waste Collected In Municipal Containers, Secondary Raw Materials And Large-Sized Waste.3. The Body Is Mounted On A Divided Frame, Flexibly Connected To The Chassis.4. Oval-Shaped Cargo Box, Each Tank Wall Made Of A Single, Uniform Sheet Of Steel (No Welds).5. The Oval-Shaped Load Box Floor Is Made Of Abrasion-Resistant Steel With A Thickness Of Min. 6Mm.6. Load Box Capacity Min. 22 M3.7. The Loading Tub Is Made Of Abrasion-Resistant Sheet Metal With A Bottom Thickness Of Min. 6 Mm, Sides With A Thickness Of Min. 4Mm.8. Fill Hopper Volume Min. 2.5 M3. 9. Drain Connector In The Loading Tub With A Ball Valve.10. Linear-Plate (Drawer) Crushing Mechanism.11. Guides Of The Pushing Plate Placed On The Walls Of The Structure.12. Possibility Of Extending The Crushing Plate Outside The Load Box To Thoroughly Clean The Box.13. Device For Opening Container Lids, Electrically And Pneumatically Controlled.14. Possibility To Control The Loading Mechanism In Automatic, Continuous And Single Cycles.15. Possibility To Control The Feeding Device Located On Both Sides Of The Abdomen.16. Possibility Of Controlling The Pushing Plate (Extension And Retraction) From A Position Outside The Vehicle, On The Side Of The Tailgate, Or From The Drivers Cabin.17. Jammed Object Release System.18. Two Safety Switches (Emergency Stop) Located On Both Sides Of The Body.19. Automatic Control Of Engine Speed Depending On The Load On The Hydraulic System.20. Degree Of Waste Density Min. 6:1.21. Possibility To Change The Pressure (Degree Of Compaction) In The Hydraulic System - Variant: Secondary Raw Materials, Green Waste. The Control Takes Place From The Drivers Cabin.22. The Edge Of The Hopper With An Opening Flap Enabling Manual Loading Of Undersized And Bulky Waste.23. Universal Loading Device Adapted To Work With Containers Of 80, 110, 120, 240, 1100 Liters.24. Rear Part (Abdomen) With Automatic Locking And Unlocking.25. Two Steps For Loaders With Sensors That Automatically Inform The Driver Which Step Is Occupied And Enable: - Limiting The Speed To 30 Km/H, - Preventing The Vehicle From Reversing, - Disconnecting The Kneading System.26. Two Crushing Press Actuators Located Outside The Abdomen.27. Seal Installed Around The Crushing Plate (Perfectly Clean Interior Of The Load Box).28. A Drain Pipe With A Leakage Valve Located At The Lowest Point Of The Bottom Of The Load Box.29. A Camera Located At The Back Of The Body And A Monitor In The Drivers Cabin.30. The Structure Is Primed And Painted Several Times According To The Ral.31 Table. Lighting In Accordance With Currently Applicable Regulations: B