Tenders Are Invited For Delivery Of Tanks For The Transport And Distribution Of Drinking Water With A Capacity Of 3000L On A Frame For Loading With A Forklift Or Hds With A Disinfection Module.

Purchase Of 2 Tanks For The Transport And Distribution Of Drinking Water With A Capacity Of 3000L On A Frame For Loading With A Fork Lift Or Hds. Technical Parameters: • Capacity [L] 3000L• Circular / Elliptical Cross-Section• Number Of Chambers: 1 With A Partition (Breakwater)• Material: Stainless Steel 0H18n9 (Aisi 304) (Din 1.4301)• External Surface Finish - Mazerized• Subframe And Structure Load-Bearing (Frames) – Galvanized Tank Equipment:• Upper Manhole Ø500 Made Of Aisi 304 With Cover And Vent, Closed With A Padlock (Flat Manhole Seal, Made Of Silicone Rubber, Inserted Into The Manhole Cover - This Prevents The Gasket From Falling Off The Manhole Chimney When Closing The Cover), • Electropolished Manifold For Filling And Draining Water From The Tank, Placed In A Closed Aisi 304 Stainless Steel Box, Equipped With: • 3 Taps (3/4 Inch), • Dn 50 Valve With A Storz Firemans Nozzle For Bottom Filling Of The Tank, • Tank Mounted On A Galvanized Frame, Adapted For Loading With A Forklift Or Hds, • Inscription On The Sides Of The Tanks: Water Potable, Drinkable After Boiling• Tanks Insulated With 60Mm Polyurethane Foam,• Tanks Equipped With A Disinfection Module - Car Body. Disinfection Module• Disinfection Of Water Taken From The Tank, Using Uv Radiation With A Dose Of Not Less Than 400 J/M2, Lamp Equipped With A Working Days Counter, The Lamp Should Be Switched On Occur Automatically, Immediately After Turning On The Module And As A Result Of The Signal Sent From The Motion Sensor, • Uv Lamp With The Possibility Of Replacing The Radiator, • The Water Installation Of The Device, Supplying And Draining Water From The Module, Should Be Made Of Stainless Steel No Worse Than Aisi 304. • The Installation Should Be Equipped With Appropriate Shut-Off Fittings With Appropriate Slopes Enabling Water To Be Drained From The Installation In The Event Of A Long Not Using The Module Or In The Case Of Maintenance Of The Uv Lamp, • The Module Must Have Its Own Power Source In The Form Of Two Gel Batteries, Each 12 V, Connected In Series, With A Total Capacity Of Not Less Than 80 Ah, • An External Socket For Charging The Batteries With A Current Of Not Less Than 10 A And A Special Main Switch Enabling Disconnection Of The Electrical Installation During Charging Batteries, • The Batteries And The Charging Socket Must Be Equipped With Fuses, • The Use Of A Main Fuse And An Auxiliary Fuse, The Role Of Which Is To Protect The Entire Electrical Installation, • The Entire Installation Must Be Equipped With A 24 V - 230 V Voltage Converter, • The Listed Elements Should Be Located In The Module Cabinet, Made Of Stainless Steel No Worse Than Aisi 304, From Inside, The Module Cabinet Should Be Lined With Insulating Boards, • The Cabinet Must Be Closed With A Cover Equipped With A Lock, Documents • Pzh Hygiene Certificate Confirming That The Tanks Are Approved For The Transport And Distribution Of Water Intended For Human Consumption In Emergency Situations, • Pzh Health Qua