Smartply Europe Dac Operates An Oriented Strand Board (O.S.B.) Manufacturing Facility At Belview Port Waterford. This Modernisation Project Will Target The Blending Area Of The Plant. Project Objectives Upgrade The Existing Blending Area Control System, Motor Control Centre (Mcc) And Plc Local And Remote-Control Cabinets To Meet Current Smartply Machinery Safety Standards, Atex Compliance And Programming Standards. Project Scope To Include: 4 X Dry Bin Infeed Conveyor System. 4 X Dry Bin Slide Gates. 3 X Dry Bins. 3 X Blender Infeeds System. 3 X Blenders. 1 X Resin, Wax And Water Addition System. Exclusions: Atomiser Control System Inside The Blenders Oem Scope. • It Will Be The Responsibility Of The System Integrator To Project Manage All Elements Of The Blending Area Control Upgrade Project I.E. System Design, Electrical Schematics And Calculation’S, Process Plc, Safety Plc, Scada Upgrade, Networking, Risk Assessment And Risk Reduction And Plant Area Atex Compliance With Reference To Applicable Standards In Appendix 1. Over The Course Of This Project A Separate Electrical Contractor Will Be Appointed To Provide Independent Installation Of Cabling, Containment, Connections, And Testing. Over The Course Of This Project A Separate Mechanical Contractor Will Be Appointed To Provide Independent Supply And Installation Of Safety Guarding And Access Gates. • The Upgrade Will Include The Replacing Of Existing Legacy Plcs With An Allen Bradley Guard Logix Area Plc System. Existing Functionality Of The Current Blender System Must Be Preserved And Available Following The Upgrade. All Signal Exchange Control / Safety To Other Mill Plcs Should Be Maintained And Realised In The New Area Plc. It Will Be The Responsibility Of The System Integrator To Program And Test The New Blending Area Allen Bradley Plc System And Provide Full Site Acceptance Testing Documentation To The Client. It Will Be The Responsibility Of The System Integrator To Provide A Declaration Of Conformity For The Blending Area Plc Control System Upgrade. • It Will Be The Responsibility Of The System Integrator To Coordinate Design And Review Meetings With The Client. Appoint An Atex Designer For The Project, Deliverables Include Complete Electrical And Loop Drawings For The Control System Detailing Is Calculations, Motor Control, And Device Field Wiring. Provide Smartply With A Field Device Parts List To Replace Existing Devices Which Comply With Plant Area Atex Requirements Smartply Will Complete Procurement Of These Parts. The System Integrator Is Responsible For Providing The Client With A Blending Plant Area Atex Verification Dossier On Project Handover This Should Include All Required Information Detailed In Appendix 2. It Will Be The Responsibility Of The System Integrator To Provide Updates For Inclusion In The Smartply Explosion Protection Document (Epd)Project Implementation Deliverables Project Implementation Phase Must Be Full Installed, Commissioned, Tested And Handed Over To The Client Following The Plant 11-Day Maintenance Shutdown. Project Preparation Work Can Be Completed On Plant Maintenance Days One Per Month. *** Please Note The Above Is Not The Full Scope Of Works - See Attached Tender Document For The Full More Detailed Scope Of Works ***
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
