1. The Subject Of The Investment Is The Performance Of Construction Works For The Task Construction Of A Warehouse For Storing Equipment Necessary To Carry Out Tasks In Crisis Situations. The Building With A Usable Area Of 347.59 M2 Will Be Incorporated Into The Existing Development Of Plot No. 366/7 In The Osiek Commune. Description Of Construction Solutions: Foundations, Footings, Foundation Walls: Foundation Footings And Monolithic Reinforced Concrete Foundation Walls Made Of C25/30 (B30) Concrete, Reinforced With A-Iii N Steel (B500sp). Foundations On A C8/10 (B10) Concrete Base, 10 Cm Thick. Foundation Footings According To Detailed Construction Drawings. Foundations And Foundation Walls Protected Against Moisture And Water According To Point Below. Walls: External Walls: Trapezoidal Sheet T35e, 0.50 Mm Thick, Positive, Fastened To Wall Transoms Z100x53/48X3.00; Transoms Fastened To The Main Supporting Structure - Ipe400 Columns In The Ground Level, Concrete Foundations Thick. 8/10Cm Wall Construction According To Detailed Construction Drawings. Walls Protected Against Moisture, Water And Thermal Protection According To Point Below. Roof: Roof With Steel Structure With Ipe400 Girders, Covered With Trapezoidal Sheet Metal T35e, Thickness 0.50 Mm Negative Purlins Z200x68/60X2.00 Columns, Reinforced Concrete Cores: Columns, Cores As The Supporting Structure Of The Roof And Stiffening The Walls, Made Of C25/30 (B30) Concrete, Reinforced With A-Iii N Steel (B500sp) In Monolithic Manufacturing Technology. In The Above-Ground Part, The Main Structural Columns Are Ipe400. Dimensions, Reinforcement, Sections According To Detailed Construction Drawings. Finish: External: Trapezoidal Sheet In Light Gray Color Internal: Trapezoidal Sheet In Light Gray Color Window And Door Joinery: Door Joinery: Steel Roof Covering: Cover: Trapezoidal Sheet Detailed The Description Of The Subject Of The Order And The Terms Of The Contract Are Included In The Annexes To This Swz (Opz And Contract Template). All Proper Names, Type Symbols And Manufacturers Markings Included In The Design Documentation (E.G. T35e, Ipe400, Z100x53/48X3.00, B500sp) Should Be Treated Solely As A Definition Of The Technical, Functional And Quality Standard. The Ordering Party Allows The Use Of Solutions Equivalent, Provided That The Offered Materials Or Products: - Have Parameters No Worse Than Those Indicated, - Meet The Relevant Pn-En Or Equivalent Standards, - Ensure That The Functional Effect Is Consistent With The Design. When Offering An Equivalent Solution, The Contractor Is Obliged To Provide: - Technical Sheets And Declarations Of Performance (Dop), - Ce Certificates, Technical Approvals, - Calculations Confirming The Load-Bearing Capacity (If Applicable). The Equivalence Assessment Will Be Performed By The Designer Or Investors Supervision Inspector Based On Documents And Technical Parameters.
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
