Submersible Pump For Draining Raw Sewage - With 10 Hp 220/380V Motor - Minimum Specifications: - Equipped With A 10 Hp Three-Phase Electric Motor Classification F, 60Hz Ip 68. - The Electrical Connection Must Enable Closing At 220 Or 380 Volts. -In The Coil There Are Thermal Sensors Installed For Protection. Maximum Rotation Of 1750 Rpm, Supplied With 10 Meters Of Electrical Cable. -It Will Be Assembled In An Existing Wet Well, Installed On Two Guide Bars. Connection To The Discharge Is Automatic Using A Suitable Guide Supplied With The Pump. Therefore, Attention Must Be Paid To The Discharge Or Discharge Diameter Of The Pump, Which Must Be 100 Millimeters, With A Solids Passage Of 90 Millimeters. -The Impeller Or Impeller Is Built In Cast Iron Gg 30 Semi Open, With 190 Millimeters In Diameter, Suitable For The Working Point, Whose Flow Is 157, 24 M³/H, For 10 M.C.A Of Height. -Oil Chamber With Double Sealing Seal, And Humidity Sensor.
We takes all possible care for accurate & authentic tender information, however Users are requested to refer Original source of Tender Notice / Tender Document published by Tender Issuing Agency before taking any call regarding this tender.
