Bids Are Invited For Acquisition Of Furniture: Tables, Armchairs, Cabinets, Chairs, Workstation And Drawers,

Meeting Table 2000 Front Panel Made From 18Mm Thick Continuous Mdf Sheet And Covered In Low Pressure Textured Melamine Film On Both Sides. Maple Tape For Covering And Finishing The Flat Edges Of The Sheet Metal, Made Of Pvc Tape In The Color And Pattern Of The Coating, With Impact Resistance And Thermally Stable. Fixed To The Substrate By The Gluing Process With Hotmelt Adhesive. With 2Mm Thickness For The Top And 1 Mm For The Other Parts. Side Headboards Located At The Ends Of The Top, With A Total Height Of 715Mm. Base Made Of Rectangular Steel Tube, 30X50mm, 1.2Mm Thick, With Plastic Finishing Tips, Fixed To The Vertical Column Using Mig Welding So That It Is Not Visible From The Outside, Guaranteeing The Quality Of The Finish. Leveling Shoes With A Base Made Of Injected Polypropylene, Measuring Approximately 30Mm In Diameter, Fixed To The Structure Using A 5/16 X 1 Threaded Bar, Making The Floor 15Mm Tall After Installation. Vertical Column Made From 1.5Mm Thick Stamped Steel Sheet, With Rectangular Section Measuring 25X200mm. Detachable Cover Located On The External Part With 200Mm Wide, Fixed To The Column Using A Sliding Fitting. Upper Beam For Supporting And Fixing The Top Made Of Rectangular Steel Tube, 20X30mm, 2Mm Thick, Fixed To The Vertical Column Using Mig Soda. The Assembly Must Be Connected To The Top Using Self-Tapping Screws And To The Front Panel Using A 25Mm Rotating Drum, M6 Quick-Mount Screw And Plastic Finishing Caps. The Connection With The Wiring Passage Rail Is Via A Semici Duct, Rectangular Office Table 1400Mm Coating In High-Resistance Melamine Laminate, Textured With At Least 0.3Mm Thick On The Top And Bottom Of The Surface, In The Color To Be Defined; Straight Edges, Throughout Their Entire Perimeter, With A Finishing Profile Made Of Semi-Rigid Polystyrene Tape, With A Minimum Thickness Of 3.0 Mm (In The Same Color As The Surface), Containing A Radius Of The Edge In Contact With The User With A Minimum Of 2.5 Mm, In Accordance With Nbr 13966, Glued Using The Holt-Melt Process (Hot); Passage For Wiring With A Textured Rigid Pvc Finish In The Same Color As The Top, With A Diameter Of 60Mm; The Lower Part Of The Top Must Contain Built-In Metal Bushings To Receive The Screws For Fixing The Top To The Metal Structure Of The Table. It Must Have A Front Panel Made Of Mpd Wood (Medium Density Particle Panels) With A Minimum Thickness Of 18.0 Mm. Low Pressure Melamine Laminate Coating On Both Sides, In The Same Color As The Work Surface. The Edges Must Be Straight And Receive Protection From Semi-Rigid Polystyrene Tape With A Minimum Thickness Of 1.0 Mm, In The Same Color As The Laminate, Glued Using The Holt-Melt Process. The Front Panel Must Be Fixed To The Structure Using Four Steel Pins With A Standard M6 Thread And A Zamak Locking Drum.