Tenders Are Invited For Removal Of Excessive Play In Loader Buckets At The Regional Waste Recovery Plant In Sianów.

Subject Of The Service: Removal Of Excessive Play In Loader Buckets At The Regional Waste Recovery Plant In Sianów, By Regenerating Holes, Bushing, Replacing Pins. 2. Intended Use: Front-Bucket Loaders With Additional Equipment Are Intended For Loading, Transporting And Forming Material At The Regional Waste Recovery Plant In Sianów.3. The Subject Of The Order Includes The Removal Of Excessive Play, Regeneration Of Holes, Bushing, Replacement Of Pins, Washing And Lubrication In The Following Loaders: 3.1 Case 721G Loader With A High Discharge Bucket• Removal Of Excessive Play, Regeneration Of Holes, Bushing, Replacement Of Pins, Washing And Lubrication Of 8 Points At The Bucket• Removal Of Excessive Clearances, Regeneration Of Holes, Bushing, Replacement Of Pins, Washing And Lubrication Of 4 Points At The Steering Cylinders• Pins Made Of 42 Crmo Steel, Heat-Treated, Induction Hardened• Bushes Made Of 55 Hrc Steel• Regeneration Of The Distance Between The Cylinders And The Bucket. Material As Original 3.2 Jcb 437 Loader With High Dump Bucket. • Removal Of Excessive Clearances, Regeneration Of Holes, Bushing, Replacement Of Pins, Washing And Lubrication Of 11 Points • Removal Of Leakage From The Main Cylinder • Pins Made Of 42 Crmo Steel, Heat-Treated, Induction Hardened • Bushings Made Of 55 Hrc Steel • Regeneration Of The Distance Between The Cylinders And The Bucket. Material As The Original 3.3 Jcb 457 Loader With A Bucket With A Pressure Flap• Removal Of Excessive Play, Regeneration Of Holes, Bushing, Replacement Of Pins, Washing And Lubrication Of 34 Points • Pins Made Of 42 Crmo Steel, Heat-Treated, Induction Hardened• Bushings Made Of 55 Hrc Steel• Regeneration Distance Between The Actuators And The Bucket. Material As The Original Attention!!!• Before Submitting Offers And Implementing The Task, The Contractor Must Undergo An On-Site Inspection And Make Detailed Measurements Of Holes, Sleeves, Pins, Etc. Failure To Carry Out An On-Site Inspection Will Result In Rejection Of The Offer.• The Ordering Party Is Not Responsible For Incorrect Measurements.• The Date Of The On-Site Inspection Is Set For: October 17, 2025 And October 20, 2025. From 6.00 A.M. To 2.00 P.M. • The Ordering Party Is Not Responsible For Incorrectly Performed Inspections. 4. Other Requirements• Warranty Of At Least 12 Months.