Tenders Are Invited For Construction Work For Research Buildings – Metallfassade

Construction Work For Research Buildings – Metallfassade. The Building Receives Approximately 3,840 M2 Rear -Ventilated Facade Clothing With The Control Structure In Non -Combustible Quality: - 18 Cm Thermal Insulation - 5.5 Cm Heavily Ventilated Air Layer - 6.5 Cm Metal Clothing On Substructure The Metal Clothing As A Meandering Aluminum Sheet U 60/60/60 Mm, Vertically Standing. In Sub -Areas, Metal Clothing Must Be Carried Out From Perforated Meandering Sheets. On The Floor, These Meander-Shaped Facade Cladding Is Structured Around The Building Using The Building. On Level Eg There Are Partial Areas With Aluminum Composite Sheets. The Ceiling Underlays Receive Clothing From Aluminum Composite Sheets. The Metal Facade Must Be Carried Out On Lightning Protection. The Metal Facade Is To Be Assembled With The Steel Construction Escape Balcony On The Back. Furthermore, The On-Site Profile Steel Elements Of The Escape Balcony As Well As The Trough Elements Of The Building On The Building On Site Must Be Disguised By Cherished Aluminum Sheets. At The Places Without A Facade Justification On The Facade, Fixed Sun Protection Slats From Aluminum Rectangular Pipes Must Be Carried Out On The Existing Steel Balance Construction. In The Area Of ​​The So -Called Facade Jump, The Metal Clothing Is Carried Out On The Partial Areas After The Construction Elevator And The Reversing Podium Could Be Dismantled. 1 Create The Execution Statics, Building Physics Calculations And Evidence As Well As Work And Assembly Planning; 2430 M2 Meander Facade; 445 M2 Perforated Meander Facade; 640 M2 Box Panel Facade; 320 M2 Aluminum Composite Panel Facade; 3710 M2 Facade Insulation; 3535 M2 Fleece/Facade Membrane; 47 M Wall Crown Cover Made Of Granted Aluminum Sheet Including Substructure; 1150 M Of Combustion Covers Made Of Granted Aluminum Sheet; 800 M2 Sun Protection Slats H = 355 Cm Made Of Aluminum Rectangular Tube 40/100 Mm Every 160 Mm; 3 Pieces Of Frame Constructions For 1-Flower Doors For Sheet Metal Clothing Approx. 165/292 Cm; 685 Meters Vertical Aluminum Tanks Of The Posts/Stems T = 2Mm Rated Several Times; 890 Meters Of Horizontal Aluminum Coalitions Of The Troge T = 2Mm Rated Several Times.