Request For Quotation Purchase Of Pumps (A Well -Wing Pump, Horizontal Console Centrifugal Pump)

The Horizontal Console Centrifugal Pump Is Designed To Pump Pure And Conditionally Pure Liquids Similar To The Physicochemical Properties Of Water, With A Temperature Of Up To 85 ° C (Or Up To 105 ° C In The Presence Of Double Seal). Gost 22247-96. The Unit Is A Horizontal Console Centrifugal Pump Installed On A Rigid Common Frame And Connected To The Drive - Asynchronous Electric Motor Through An Elastic Coupling. The Drive Is Made With The Possibility Of Craft Gear. The Diameter Of The Seating Of The Engine Of The Engine Is At Least 28 Mm. An Electric Motor With A Capacity Of At Least 5.5 Kilowatts, With A Rotation Frequency Of At Least 3000 Revolutions Per Minute, Provides The Necessary Performance And Pressure Corresponding To The Working Characteristics Of The Pump. The Supply (Q) Is Not Less Than 20.0M³/H, The Pressure (H) Of At Least 30.0 M. The Permissible Diameter Of Solid Inclusions In The Liquid Is Not More Than 0.2Mm. The Maximum Content Of Mechanical Impurities Is Not More Than 1% By Mass. Pump Body: Made Of Cast Iron, Working Wheel: Made Of Cast Iron, Pump Shaft: Made Of Carbon Steel. Val Seal Type: Saline Seal (With The Possibility Of Installing Double Sealing At A Temperature Of Up To 105 ° C), The Well -Loaded Pumping Pump Is Designed To Supply Clean Water From Wells, Wells And Other Sources Up To 113 Meters Deep. Suitable For Domestic And Industrial Water Supply, Including Irrigation Systems, Automatic Water Supply Systems, Increasing Pressure And Other Engineering Solutions. Gost 31840-2012. Type Of Water Pump Submersible. The Type Of Submersible Pump Is Well. The Type Of Water Is Central. The Principle Of Action (Pump Mechanism) Is Centrifugal. The Material Of The Case Is Stainless Steel With Corrosion Resistance. Maximum Performance Of At Least 55 Liters Per Minute (Or 3.3 M³/H). The Maximum Pressure Of At Least 113 Meters Of Water Column. The Operating Voltage Of The Mains Is 220 V ± 10 %, 50 Hz. The Nominal Power Of The Electric Motor Is Not More Than 750 Watts. The Diameter Of The Thread Of The Output Pipe (Thread G) Is At Least 1 Inch. The Outer Diameter Of The Pump Is Not More Than 77 Mm (Under A Well With A Diameter Of 80 Mm And Above). The Length Of The Power Cable Is At Least 18 Meters. The Maximum Permissible Water Temperature Is Not More Than 40 ° C. The Degree Of Protection Against Water And Dust: The Equipment Should Be Completely Protected From Dust And Intended For A Long Stay Under Water. The Material Of The Working Wheels Is A Polymer Of High Strength Or Stainless Steel. The Type Of Installation Is Vertical, Complete Immersion. The Minimum Water Level Above The Pump Is At Least 0.5 M. The Set Is A Control Panel Or A Control Panel. The Condition Of The Equipment Is New, Not In Operation, Without Damage, In The Original Packaging. Supply Set Of The Pump Assembly, Power Cable With A Length Of At Least 18 M, A Remote Control Or Control Panel, Passport, Operating Instructions, Warranty Coupon.