Tenders Are Invited For Construction Of A Rescue And Fire-Fighting Unit In Bialystok- Stage Iv, Execution Of The Exhaust Gas Extraction System For Fire Vehicles

3 Plabowa 95 As Described By The Subject Of The Order, I.E. Purpose Of The Exhaust Gas System Is Aimed At Effective Removal Of Exhaust Gases Formed During Starting And Movement Of Fire Vehicles In The Garage Hall, In Order To Ensure The Safe Working Conditions Of Firefighters And To Meet The Health And Safety Requirements And Environmental Protection. General Requirements: A) The Factory System New (I.E. Unregenerated, Unrefined, Non -Fabricated, Unused In Previous Projects), Complete (In Particular With All Components, Parts, Materials Necessary To Start And Use And Wiring), B) Produced Not Earlier Than In The Year Of Delivery, C) Intended For Pulling Out The Exhaust Gas From Engines, D) Adapted To Work In Garage With The Height Of The Hall 5.85 M, E) All Devices Come From The Official Distribution Channel Of The Manufacturer Providing Full Warranty And Service Support In Poland, F) The System Includes: ⎯ The Exhaust Gas Extraction System Containing All The Necessary Elements For Proper Functioning As Intended, With The System Of Automatic Drainage Of The Suction With A Lower Exhaust System, Including: • Channel Samo-Sealing Length 10 M- 3 Set (1 Trolley On Each Channel), Located In Pom. No. 1.06 Ground Floor Projection Fig. (1 Trolley On Each Channel), Located In Pom. No. 1.13, The Ground Floor Projection Fig. (+ 2 Sets Of Prams And Sugars), Located In Pom. No. 1.13, The Ground Floor Projection Fig. No. 1.14, The Ground Floor Projection Fig. Devices And Assembly And Control Elements, Iii. Technical Parameters) System Type: ⎯ Sliding (Rail) With Automatic Detachment Of The Tip At The Vehicles Departure, Number Of Subtituting Stations - 8 And Drum, Number Of Positions - 1, B) Number Of Subtituting Stations: 9, C) Driving Rail Length: Adapted To The Hall System, Number And Location Of Vehicles, A Given Manufacturer System, D) Performance Of The Fan: The Installation Is To Be So That The Concentration Of Harmful Gases During The Operation Of All Engines Does Not Exceed Nds At The Door Closed. The Fans Are To Be Equipped With Supply And Maintenance Units, Allowing Time With A Set Delay, E) Noise Level: ≤ 70 Db (A) With Maximum Performance, The Fans Should Be Equipped With Noise Suppressors And, If Necessary, Use Channel Noise Suppressors, F) Flexible Wires: Diameter Free Escape From Truck Engines. The Suction Cable Should Be Finished With A Suction. The Suctionline Is To Be Constructed Of Materials Guaranteeing The Safety Of Staff And Vehicles In A Situation Of Accidental Impact With A Magnetic Tip Fitted To The Exhaust Pipes Of Vehicles, Attachment Of The Suction Board On The Side Of The Vehicles Body Using An Electromagnes By Damaging The Bodys Body, The Suction Board After Automatic Detachment From The Vehicle Must Not Fall Loosely To The Floor, Flexible Cables Cannot Create Hanging Loops Hindering Communication In Positions, G) Power Supply: Single -Phase 230/400 V, 50 Hz, H) Control: Automatic Activation Of The Fan With The Switching Of The Veh