Bids Are Invited For Acquisition Of Pantograph Treadmill To Block Vehicle Escape, Portable Spine And Smart Road Tachão Kit For Use Of Acadepol - Sc.

Reflective Tachao For Transit Signification Reflective Tacket For Traffic Signification - Light Led Sick Kit, Battery And 6 (Six) Side Road Tails Kit. Kit Composition: Set Containing 6 (Six) Intelligent Road Tacks, Accompanied By Appropriate Transport Suitcase And Battery Recharge System.2. Dimensions Of The Tacks: Each Unit Must Present The Following Approximate Measurements: Length: Between 100 Mm And 110 Mm; Width: Between 90 Mm And 95 Mm; Height: Between 30 Mm And 35 Mm. 3. Degree Of Protection: Minimum Protection Required: Ip66, Ensuring Dust And Water Resistance.4. Additional Magnetic Fixation: In Addition To The Application On Road, The Tacks Must Have A Magnet Base, Allowing Their Fixation On Metal Surfaces, Such As The Bodywork Of Vehicles Or Various Metal Structures.5. Food And Autonomy: Feeding By Rechargeable Alkaline Batteries Or Rechargeable Batteries. Minimum Autonomy Of 12 (Twelve) Hours Of Continuous Operation. 6. Recharging System: Must Have Simultaneous Recharging Device Of All Tacks, Properly Accommodated In A Specific Receptacle Included In The Bivolt Input Voltage (110V/220V) And Compatibility With Vehicle Feed (12V To 24V) .7. Lighting System: Led Lighting In Red Or Amber (Yellow). Each Tachão Must Contain At Least: 12 (Twelve) Leds Distributed On The Sides; 4 (Four) Leds At The Top.8. Light Dispersion: Horizontal View Angle: 360 ° (Degrees); Vertical View Angle: 180 ° (Degrees) .9. Intermittent Modes: The Flashes Control System Must Have At Least Five Distinct Flashing Patterns, Including: Simultaneous Flashes Of All Panels; Synchronized Sequential Flashing Between The Tacks., Materials And Components For Signaling, Control And Alarm Materials And Components For Signaling, Control And Alarm - Portable Spine Modular Portable Spine1. Purpose: Portable Equipment For Temporary Reduction In Vehicle Speed2. Total Length: The Spine, When Fully Extended, Must Have A Total Length Of Approximately 3 (Three) Meters.3. Modular Structure: Composed Of Continuous Segment Of Interconnected Modules, Made Of Compact And Resistant Plastic. 4. Articulation System: Modules Must Be Coupled With Each Other By Plastic Hinge Joints, Allowing Longitudinal Flexibility And Facilitating Handling During Installation And Collection. The Structure Must Maintain Stability And Linearity When Positioned On The Floor.5. Non -Slip Base: The Support Base Should Be Composed Of High -Adhesion Rubberized Material, Which Ensures The Spine Stability On The Floor, Including Under Rain Or In Low Friction Floors, Without The Need For Permanent Fixation.6. Visibility: Modules Should Be Produced In A Living Yellow Color, With The Presence Of Reflective Lanes Incorporated Into The Surface To Ensure High Night Visibility And In Adverse Lighting Conditions.7. Load Capacity: The Spine Should Withstand Vehicles With A Minimum Total Load Of 40 (Forty) Tons Without Structural Deformation Or Performance Impairment. 8. Resistance And Durability: Should Have Resistance To Uv Radiation., Police Materials Materials For Police Use - Perforator Plocker Blocker Pantograph Stand For Vehicle Escape Block 110 Pins. 2. System Of Action: The Equipment Must Allow The