Tenders Are Invited For Basic Mode Without Negotiations On The Implementation Of The Task Entitled Modernization Of The Building Of The School And Preschool Complex No. 3 In Nakło Nad Notecią.

In Order To Adapt The Building To The Requirements Of Fire Expertise, The Following Works Should Be Carried Out: 1. Performing A Fire Detection System Based On A Microprocessor Fire Detection Center, Smoke Point Detectors, Rops And Acoustic Signals. The Detection System Will Include Corridors And The Locker Room Rooms. A System Operating On The Basis Of Two -Stage Alarm With The Possibility Of Connecting To Psp In Nakło Nad Notecią. 2. In Addition, The Building Envisages The Expansion Of The Existing Emergency Lighting Installation, And Evacuation And Emergency, Emergency Lighting Is Designed In Accordance With The Following Standards: Pn-En 1838 And Pn-En 50172. In The Event Of Tension Disappearance-To Ensure Efficient Evacuation, Emergency Luminaires Are Designed Equipped With Your Own Energy Sources-Battery Battery With An Inverter With An Inverter At Min. 1H. Emergency Luminaires Equipped With Autotest Functions. Emergency Luminaires Will Be Switched On After The Supply Of Power Supply (Work Dark). Evacuation Luminaires Equipped With Pictograms Indicating The Directions Of Evacuation Will Work In Light Mode. Emergency And Evacuation Luminaires Will Be Switched On After The Supply Of Supply Voltage. The Average Lighting Intensity On The Ground Along The Middle Line Of The Escape Route Should Be Not Less Than 1Lx. The Average Intensity Of Evacuation Lighting In The Open Zone Should Not Be Less Than 0.5Lx At The Floor Level, In The Undeveloped Active Field Of The Open Zone (Except For The Peripheral Belt With A Width Of 0.5 M Wide). In The Area Of Fire Devices, Fire Buttons, Hydrants, Lighting Intensity On The Floor Should Be At Least 5Lx. Installations Lead In A Surface -Mounted Manner. 3. Two New Rpwp Wardrobes Are Planned For The Fire To Switch Off The Fire. The First Located Inside The Building At The Main Supply Of The Building (Entrance Hall), The Second Located In The Separate Room Of The Main Building Switchgear On The Ground Floor. Wardrobes Should Be Connected To Each Other In Such A Way That The Operation Of Any Of The Pwp Buttons On The Facility Resulted In The Disconnection Of Both Power Sources. The Building Is Planned To Install Three Pwp Buttons At The Main Entrances To The Building (In Accordance With The Guidelines Of The Port Expertise). Electric Ones Should Be Made In Accordance With The Requirements Of The Pn-Hd Standard 60364-5-56: 2019-01. Installation Is Carried Out In A Surface -Mounted Manner. Closing On The Ground Floor With The Ei 30 Fire Resistance Class And Smokeproof Entrance To The C Segment From The Segment Corridor A Corridor (Nursery Area). Conducting Dismantling And Re -Assembly Of Intercom Systems And Access Control At The Above -Mentioned Transitions. Execution Of Construction Repair Work After The Changes. Delivery Of The Door To The Main Distribution Room Of The Building And The Execution Of Fire Protection Crossings. To The Above -Mentioned Room. The Concise Description And The Scope Of The Task Were Spec