repair work in km 3 to 4 of garh chowpla to garh gaga mela road in hapur district - providing & laying spreading and compacting graded stone eggregate to wet mix macadam specification prembong the matenal with water at omc in mechanicalplant carriage of mixedmaterial by tpper to site laying in uniform layer with paver in sub-base/base coarse on wel prepared surface and compacting with vibratory roller to achieve the desired density, mort&h-406. 2 providing and applyng tack coat with 80/100 bitumen emulsion using emulsion pressure distributor at the rate of 0.30 kg. per sqm. on the prepared bituminous/ granular surface cleaned with mechanical broom, including supply of al materials, labour t&p otc required for properompletion of the work as per clause - 503 of mort & h specifications and as per direction of the engineer-in-charge. (ar) 3 providing and layingbituminous macadam with higher capacly batch type hmp using crushed specified groding, premixed with bituminous binder @ 4.5 per cent by weight of total mix and file transporting the hot mbx to work sto laying with a hydrostatic paverinisher with a hydrostatic paver finisher with sensor control to the required grade, level and alignment. rolling with smoothmheeled, vibratory and tandem rollers to achieve the desired compaction as per morth specification clause no. 505 complete in all respects. 4 providing and laying bituminous concrete (gr-il) with 120 tph batch type hot mix plant using crushed aggregates from approved quarry of specified grading. premixed with bituminous binder (vg-30) @ 5.40 per cent of mix and filler. transporting the hot mix to work site, laying with a hydrostatic paver finisher to the required grade, level and alignment, rolling with smoothheeled, vibratory and tandem rollers to achieve the desired compaction as per morth pecification clause no. 507 complete in all respects adjustment for bitumen shall be done as per job mix formula and e-in-c letter no 2651 dt 27-07-12. (using plastic waste @ 6% of bitumen weight) 5 road marking with hot applied thermoplastic compound with m reflectorising glass beads on bituminous surface. (repeated/80 tranvers bar) providing and laying of hot applied thermoplastic compound 2.5 sqr thick including reflectorising glass beads @ 250 gms per sqm area, thickness of 2.5 mm is exclusive of surface applied glass beads as per irc:35-2015 the finished surface to be level, uniform and free from streaks and holes. 6 brick edging in full brick width and half brick depth including excavation, refilling and disposal of surplus earth lead upto 50 metres.with common burnt clay f.p.s. (non modular) bricks of class designation 7.5dsr-2023/16.7.1