tender for renewal work of service road from km 21.800 to 22.800 at maudaha branch - cutting heavy under and bushes upto 7.5 cm dia including. 2 wbm grading 2 providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing , rolling with smooth wheel 80-100 kn in stages to proper grade and camber, applying and brooming, stone screening/ biding materials to fillup the interstices of course aggregates, watering and compacting to the required density grading 2 as per mord technical specification clause 405 3 wbm grading 3 providing, laying,spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing , rolling with three wheel 80-100 kn static roller in stages to proper grade and camber , applying and brooming, crushable screening to fillup the interstices of course aggregates , watering and compacting to the required density grading 3 as per mord technical specification clause 405 4 providing and applying prime coat with bitumen emulsion (s.s.-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70-1.0 kg/sqm using mechanical means as per technical specification clause 502 5 providing and applying tack coat with bitumenusing bitumen v.g.-10 distributor at the rate of 0.25 to 0.30 kg per sqm on the prepared dry and hungry bituminous surface cleaned with hydraulic broom as per technical specification clause 503. 6 providing laying & rolling of open graded premix carpet of 20 mm thickneess composed of 13.2 mm to 5.6 mm aggregates using vg-10 grade bitumen to required line, grade and level to serve as wearing course on a previously prepared base, including spreading mixing in a suitable plant, laying and rolling with three wheel 80-100 kn static roller in capacity, finished to required level and grades to be followed by seal coat-technical specification clause 408 7 providing and laying seal coat by mannual means with vg-10 gr.grade bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using type cas per technical specification clause 510 8 providing and laying hot applied thermoplastic compound 2.5 mm thick including reflecorising glass beats @ 250 per sqm. area thickness of 2.5 mm exclusive of surface applied glass beats as per irc : 35 the finished surface to be level, uniform and free from streaksand holes at site 9 providing and fabricating ms sign board of size 4×3 using isa 40×40×6 mm and 25x3 mm flat iron bracing with 18 swg ms sheet with one coat of red oxide primer to fixed at 11 level of minimum 3 from round and 2 deep into the ground with 3 angle cut and turned to opposite side to make a hold fast and steel angle i/c all cost of all labour, material, paiting letter writting etc. as per direction and fully satisfaction of engineer in charge. 10 note-the quantity may varies as per site condition and contractor will bound to excute without any extra claim.