annual plan-prj no. 35/26 kalathoor samskarika nilayam maintenance ward 14-35/26 sooranad north gramapanchayat-general civil work -- 1 building maintenance 2 13.88:removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete. 3 13.111.1:finishing walls with acrylic smooth exterior paint of required shade :old work (two or more coat applied @ 1.67 ltr/ 10 sqm) on existing cement paint surface 4 13.99.1:painting with synthetic enamel paint of approved brand and manufacture ofrequired colour to give an even shade :one or more coats on old work 5 13.105:re-lettering with black japan paint of approved brand and manufacture. 6 2.32:clearing grass and removal of the rubbish up to a distance of 50 m outside the periphery of the area cleared. 7 2.6.1:earth work in excavation by mechanical means (hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by engineer-in-charge.all kinds of soil 8 4.1.4:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:2:4 (1 cement : 2 coarse sand (zone-iii) derived from natural sources : 4 graded stone aggregate 40 mm nominal size derived from natural sources) 9 10.16.1:steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.hot finished welded type tubes 10 13.61.1:painting with synthetic enamel paint of approved brand and manufacture to give an even shade:two or more coats on new work 11 od257001/2025-2026:providing and fixing precoated galvanised iron profile sheets (size, shape and pitch ofcorrugation as approved by engineer-in-charge) 0.35 mm (+0.05%), total coatedthickness with zinc coating 120 grams per sqm as per is: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side. of the sheet and polyester top coat 15- 18 microns.sheet should have protective guard film of 25 microns minimum to avoid scratchesduring transportation and should be supplied in single length upto 12 metre or as desiredby engineer-in-charge. the sheet shall be fixed using self drilling/self tapping screws ofsize (5.5x55mm) with epdm seal, complete upto any pitch in horizontal/ vertical orcurved surfaces, excluding the cost of purlins, rafters and trusses and including cutting tosize and shape wherever required. 12 od236268/2025-2026:supplying and fixing 150mm pvc square rain water gutter section including fittings with 32x5mm flat supports at 1 m interval etc complete 13 4.1.8:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:4:8 (1 cement : 4 coarse sand (zone-iii) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) 14 50.6.2.1:solid block masonry using pre cast solid blocks (factory made) of size 30x20x15 cm or nearest available size confirming to is 2185 part i of 1979 for foundation and plinth with thickness 15cm in: cm 1:6 ( 1 cement :6 coarse sand) etc complete 15 13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) 16 od257000/2025-2026:providing and laying 60 mm thick factory made cement concrete interlocking paver block of m - 30 grade made by block making machine with strong vibratory compaction, of approved size, design & shape, laid in required colour and pattern over and including 50 mm thick compacted bed of 6mm chips, filling the joints with fine sand etc. all complete as per the direction of engineer-in-charge. 17 11.37:providing and laying ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to is : 15622 of approved make in colours such as white, ivory, grey, fume red brown, laid on 20 mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete