tender for atmaram inter college ballia bareilly. (alankar yojna), 1 boq 2 earth work in excavation by mechanical means (hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. 3 1:4:8 (1 cement : 4 coarse sand (zone-iii) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) 4 along external wall where the apron is not provided using chemical emulsion @ 7.5 litres / sqm of the vertical surface of the substructure to a depth of 300mm including excavation channel along the wall & rodding etc. complete:with chlorpyriphos/ lindane e.c. 20% with 1% concentration 5 brick work with common burnt clay f.p.s. (non modular) bricks of class designation 7.5 in foundation and plinth in:cement mortar 1:6 (1 cement : 6 coarse sand) 6 reinforced cement concrete work in beams, suspended floors, roofs having slope up to 15° landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement : 1.5 coarse sand(zone-iii) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources). 7 same as item no. 5 but in slab as per dsr 2023 item no-5.3. 8 steel reinforcement for r.c.c. work including straightening, cutting, bending, placing in position and binding all complete aboveplinth level.mild steel and medium tensile steel bars 9 steel work welded in built up sections/ framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required.in gratings, frames, guard bar, ladder, railings, brackets, gates and similar works 10 filling with available fly ash and earth (excluding rock) in trenches or embankment in layers (each layer should not exceed 15 cm), with intermediate layer of compacted earth (soil density of 98%) after every four layers of compacted depth of fly ash, sides & top layer of filling shall be done with earth having total minimum compacted thickness 30 cm or as decided by engineer -in-charge, including compacting each layer by rolling/ ramming and watering, all complete as per drawing and direction of engineer -in - charge. 11 supplying and filling fine sandin plinth withsand under floors, including watering, ramming, consolidating and dressing complete. 12 brick work with common burnt clay machine moulded perforated bricks of class designation 12.5 conforming to is: 2222 in superstructure above plinth level up to floor five level in cement mortar 1:6 (1 cement : 6 coarse sand) : 13 providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to is: 15622, of approved make, in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sqmincluding grouting the joints with white cement and matching pigments etc., complete.size of tile 600x600 mm 14 1:2:4 (1 cement : 2 coarse sand (zone-iii) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources) mm 15 cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete.40 mm thick with 20 mm nominal size stone aggregate 16 providing 3.5 mm thick 2.2 cm deep glass strip in the joint of floor 17 12 mm cement plaster finished with a floating coat of neat cement of mix :1:3 (1 cement: 3 fine sand) 18 12 mm cement plaster finished with a floating coat of neat cement of mix :-1:6 (1 cement: 6 coarse sand) 19 15 mm cement plaster on rough side of single or half brick wall of mix:-1:6 (1 cement: 6 coarse sand) 20 providing and applying plaster of paris putty of 2 mm thickness over plastered surface to prepare the surface even and smooth complete. 21 distempering with 1st quality acrylic distemper (ready mixed) having voc content less than 50 gram/litre, of approved manufacturer and of required shade and colour all complete to achieve even shade and colour : 22 finishing walls with acrylic smooth exterior paint of required shade : 23 painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade : 24 providing and laying ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer), of 1st quality conforming to is : 15622, of approved make, in all colours, shades, except white, ivory, grey, fume red brown, laid on 20 mm thick bed of cement mortar 1:4 (1 cement : 4 coarse sand), jointing with grey cement slurry @ 3.3 kg/ sq.m including pointing the joints with white cement and matching pigments etc., complete. 25 providing and fixing fly proof galvanized m.s. wire gauge to windows and clerestory windows using wire gauge with average width of aperture 1.4 mm in both directions with wire of dia 0.63 mm all complete.with 12 mm mild steel u beading 26 provind and laying brick coba 12 mm thick laid with m-150 class brick bat coba 7.50 cm thick with gap of 15 mm to each other over 20 mm thick base of cement mortar 1:4 cement and coarse sand mixed with water proofing compound spreading cement slurry mixed with aerelic mortar cement concrete water proofing compound filled gaps of coba & top of coba mortar mixed with water proofing compound in 1:4 cement and coarse sand mortar finished smooth & top square marks 30 cm x 30 cm . and side wall parapet shall be monoltythic plaster wall upto 30 cm higher and junction and corner shall be rounded by brick ballast cement and coarse sand masonary & coba with top finished plaster mixed with acetic water proofing compound @ 2% by wight & including s/o all material, labour t & p etc. complete for proper completion of work. asper dsr 22.7.1 27 s/f of fan box of 16 mm dia.complete of wok as per sor si no. 1149. 28 s/f of 10 cm. dia p.v.c.down pipe (kissan,supreme or equivalent) 6kg/sq. cm. ……….comp.as per sorsi no.730b 29 providing and laying of factory made 80 mm thick interlocking cement concrete tiles (30mpa) including 25mm thick compcated bed of fine sand compacting and proper laying of interlocking tiles. as per dsr 16.91.2 30 s/f of informatery sign board/ innaugaration stone 31 s/f of c.p.v.c. pipe 100mm dia including all complete. 32 providing and placing on terrace (at all floor levels) polyethylene water storage tank, is : 12701 marked, with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank. 33 cpvc pipe 20 mm nominal dia pipes 34 cpvc pipe 15 mm nominal dia pipes 35 white vitreous china orissa pattern w.c. pan of size 580x440 mm with integral type foot rests 36 s/f of full way gate valve all complete of work. 37 white vitreous china wash basin size 630x450 mm with a single 15 mm c.p. brass pillar tap 38 p/f of c.p. brass bib cock of 15mm dia nominal bore…….. including all complete of work.as per dsr 18.49.1. 39 p/f of c.p. brass long body bib cock of 15mm dia nominal bore…….. including all complete of work.as per dsr 18.51.1. 40 p/f of c.p. brass stopcock of 15mm dia nominal bore…….. including all complete of work.as per dsr 18.52.1. 41 wiring point for light1.5 sq. mm.frlsh pvc insulated multistrand single core copper conductor cable in pvc conduit pipe concealed in the wall, complete with 14 swg copper earth continuity wire,inside the conduit using moduler board & moduler switch complete . (a) light points (131c +187a) 1.8.1 42 (b) fan points (133c +187a) 43 (c) 5amp. plug (134c +187c) 44 supply and fixing of power plug with 20 amp./250 volt flush type modular switch and 5 pin 20 a/250 volt flush type universal modular socket switch on concealed m.s box including supply of all material, labour t&p etc. required for proper completion of work.(1139a) 45 s&f of 5 amp to 32 amp. 240/415 volt 10ka spmcb 46 supply and fixing of electronic fan regulator( modular) 120-280 v. isi marked, on the existing switch board including making connections, required material, labour t&p etc. for proper completion of work to the satisfaction of engineer in charge of work (1203c) 47 supply and fixing of led tube light batten fitting suitable for up to 1 x 22 watt led tube light on surface complete in all respect.(1413a cat aaa) 48 supply and fixing of led street light fitting having die cast aluminium body and diffuser with driver set suitable for 45 watt to 50 watt. confirming to ip 66 protection complete in all respect.(1421 cat aaa) 49 supply & fixing following way, shine pole and naturalsheet steel mcb distribution board 240 v including all. 8 way double door 50 supply of 1200 mm sweep ceiling fan complete including downrod and blades complete in all respect (havells make model es plus 2star. 51 supply of 250 mm sweep vent air ( havells make px white model)