tender for repair to e / m installation at dronachal bhopal. -demolition of cement concrete (un-reinforced) in ground floors and pavings n. exc. 15 cm thickness (below or above ground level) completed all as specified and directed. 2 m&l for 100 mm thick pcc 1:3:6 type c2 (using 40 mm graded stone aggregate) as sub base floor completed all as specified and directed. 3 m & l for sand filling under floors or in fdn including watering and consolidation as in bedding layers for laying tiles completed all as specified and directed. 4 m&l for factory made machine pressed precast concrete interlocking paver blocks any shape and size confriming to is 15658-2006 of 60mm thickness coloured chemically treated pcc (isi marked ) m-35 grade of desgin & pattern approved by ge as in footpath and filling of joints with narmada fine sand complete all speciified and directed. 5 m & l machanic pressed precast concrete interlocking paver block any shape and 80mm thickness, jointed and pointed with grey cement and pigment in floor/ footpath completed all as specified and directed. 6 m&l pcc 1:2:4 type b-0 (using12.5mm graded crushed stone aggregate) as incoping including weathering, slightly rounded or chamfered angles and throating, as directed and necessary form work complete all as specified and directed. 7 dismantling of stone slabs and tiles of any description or thickness in floor, aprons etc laid dry or laid and pointed in floor/ footpath complete all speciified and directed. 8 labour for except tiles machine pressed precast concrete interlocking paver blocks any shape and size of 60mm thickness coloured of desgin & pattern refixing in floor/footpath and filling of joints with narmada fine sand complete all speciified and directed. 9 dismantling of existing rcc/ steel /wooden posts or struts (wood, steel or r.c.c.) any section,concrete ,brick work ,massonery etc .including taking out embedded portion and making good disturbed ground complete all speciified and directed 10 dismantling wrought iron or mild steel work of any description not otherwise provided for completed all as specified and directed. 11 dismantling fencing wire mesh, any type. 12 m & l excavating in post holes (or similar holes) each n exc 0.5 cum , getting out , returning , filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, watering , and removing surplus soil to a distance n exc 50 m and making good surfaces in hard/dense soil completed all as specified and directed. 13 m&l pcc 1:3:6 (type c2) (using 40 mm graded stone aggregate) as in foundation filling and massconcrete completed all as specified and directed. 14 s&f post and strut in fencing including cutting tops to shape as directed drilling holes notching for wire flat iron fillet ( for securing wire mesh) in incl all necessary drilling bolting,screwing and rivetting conforming to fe-290gd-165 completed all as specified and directed. 15 supply only mild steel screw bolt ( maching made) with hexagonal or square head at one end and screwedthe other with washer n.exc 5 cm long dia bolt 5 to 10mm completed all as specified and directed. 16 m&l for ms round bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all speciified and directed 17 supply only chain link ms galvanisd fencing, any size or type complete all as specified and directed. 18 fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed. 19 s&f, galvanised 2 strand steel barbed wire 2.24mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of standard rails straining bolts including securing or tying at crossing with and provision of galvanised mild steel wire completed all as specified and directed. 20 m&l preparation of new steel surface of any description over 10cm width or girth and applyingtwo coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. 21 m & l for two coat of synthetic enamelpaint over priming with red oxide zinc on new or prevously untreated surface of any description not exc 10 cm in width or girth when unconnected with other painting or painted in different tint completed all as specified and directed. 22 m&l preparation of old steel surfaces of any description over 10 cm width or girth not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed. 23 dismantling structural steel work including doors, gates and framed truss etc completed all as specified and directed. 24 m&lmild steelframed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing with welding all are as complete confirming to fe410-s completed all as specified and directed. 25 demolition of brick work or stone /boulder masonry built in cement mortar including all quoins, arches, pillers etc. butexcluding ashlar facings, dressed stone work and precast conc rete articles completed all as specified and directed. 26 demolition of pcc of any description and in any position not otherwise specifically provided for complete all as specified and directed 27 demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for complete all as specified and directed 28 m&l pcc 1:3:6 (type c2) (using 40 mm graded stone aggregate) as in foundation filling and massconcrete 29 m&l forbrick work withfly ash modular bricks ,straight or curvedon plan exc 6 m meanradius built in cement mortar1:6 complete all as specified and directed. 30 m&l for walling of random rubble uncoursed well bounded, bedded, and solidly hearted, builted in cement mortar 1:6 complete all as specified and directed 31 description all as per item no 30 above but except stones complete all as specified and as directed. note:- old stone obtained from demolition shall be used under this item. 32 m&l forproviding precast cement concrete type b11:2:4 (20mm graded aggregate)asin cover slabs (for manholes, drains etc.) of any size and thicknessas requiredset in cement mortar 1:4 note :- reinforcement will be measured and paid saperately 33 m&l mild steel tmt bars 10 mm dia and over cut to length bent to sharp required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) but less than 0.9 mm dia securing with clips completed all as specified and directed. 34 m&l for rendering 15mm thick cement plaster in cm 1:4 and even on fair faces ofbrick or concrete surfaces finished even & smooth without using extra cement completed all as specified and directed. 35 m&l flush pointing to random rubble, uncoursed or brought upto courses in cement mortar 1:4 complete all as specified and directed. 36 m&l for preparation of old decorated surfaces of wall including brooming , scraping down. smoke spot, moss, efflorescent salts, trading oil, grasy spotsand stopping nails marks by applying white cement base putty in patches as required and one coat of white wash on ceiling completeall as specified and directed. 37 mateirial & labour for preparation of old decorated surfaces on walls including brooming , scraping down. smoke spot, moss, efflorescent salts, trading oil, grasy spotsand stopping nails marks by applying white cement base putty in patches as required and one coat of white wash on walls completeall as specified and directed. 38 m&l for complete removal of existing treatement on walls and applying two coats of cement base paint over a coat or alkali resistan primer completed all as specified and directed. 39 taking down cement plaster of any description including raking outjoints, hackisng for key, scrubbing down with water etc completed all as specified and directed. 40 material and labour for rendering 10 mm thick in cement and sand mortar 1:6 on fair faces of brick work or cement concrete surfacesfinishing the surface even and smooth without using extra cement including preparation of newly plastered surfaces of walls and applyingtwo coat of oil bound distemperover& inculdinga coat of white cement base puttycompeletall as specified and directed. 41 -ditto- all as per srl item no.40 here-in-before, but 15mm thick in cement mortar 1:4 finished fair and even using integral waterproofing compound for wall, chajja, fins, sides including preparation of newly plastered surfaces of walls complete. note:-supply only of wpc shall be measured and paid separately. 42 material and labour for rendering 5 mm thick in cement and sand mortar 1:4 on concrete surfaces of ceiling finishing the surface even and smooth without using extra cement including preparation of newly plastered surfaces of walls and applying three coats of white wash completed all as specified and directed. 43 supply only integral water proofing compound 44 repair to rolling shutters of size n. exc 10 sqm each, manual/gear operative type, denting of various parts, cleaning of guide rails, laths, top cover by kerosene and proper greasing , oiling to make the system smooth/easy functional, including new nuts & bolts and greasing of gear box by removing old/rusted nuts bolts, giving proper tension to the spring, necessary welding & taking down shutter wherever required and fixing of hold fast/clamp and making good matching to existing wall surface complete all as directed(new fittings except mentioned parts will be measured and paid saperately) 45 s & f in repair cover hood of 1mm thick ms sheet matching to existing shape complete all as specified and directed. 46 s & f in repair rolling shutter lath 1mm thick ms sheet matching to existing complete all as specified and directed. 47 s & f in repair ms bracket plate to the side of cover hood made of 6mm to 8mm platecomplete all as specified and directed. 48 taking down existing unserviceable treatment of any description including cement plaster, any thickness from roof surfaces, cleaning of roof surfaces and preparing it for further treatment and removing rubbish from the site up to 50 mtrs complete all as specified and directed 49 m&l for 25mm thick pcc 1:2:4 type b0 (using 12.5mm graded stone aggregate) as in levelled course finish even and fair for tile finishes specified and directed 50 m&l for brushing neat cement slurry with 3.0 kg of cement per square metre complete all as specified and directed. 51 m & l 15mm thick rendering in cm 1:3 mixed withwater proofing compound over rcc roof slab finished even and smooth without extra cement complete all as specified and directed. note : wpc will be measured and paid separately 52 m&l for applying one coat of bonding material using blown type bitumen conforming to is-702 grade 85/25 @ 1.20 kg/sqm l over a coat of bitumen primer on finished plastered surfaces complete all as specified and directed. 53 m&lfor app based polymeric membrane minimum weighing 3kg/sqm and min 3mm thick reinforced with polyster non wove fabic (wt not less than 150 gms/sqm) including priming of surfaces by forced application complete all as specified and directed