general-so 222/26-renovation of kalamassery market-general civil work --- 1 market building 2 15.9.1:demolishing stone rubble masonry manually / by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of engineer -in- charges:in lime mortar 3 15.7.1:demolishing brick work manually / by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of engineer-in-charge.in mud mortar 4 15.3:demolishing r.c.c. work manually / by mechanical means including stacking of steel bars and disposal of unserviceable material with in 50 metres lead as per direction of engineer -in-charge. 5 2.6.1:earth work in excavation by mechanical means (hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by engineer-in-charge.all kinds of soil 6 4.1.8:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:4:8 (1 cement : 4 coarse sand (zone-iii) derived from natural sources : 8 graded stone aggregate 40 mm nominal size derived from natural sources) 7 5.9.1:centering and shuttering including strutting, etc. and removal of form for:foundations, footings, bases of columns, etc for mass concrete 8 5.1.2:providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - all work up to plinth level:1:1:5:3 (1 cement 1.5 coarse sand :3 graded stone aggregate 20 mm nominal size derived from natural sources) 9 50.6.2.1:solid block masonry using pre cast solid blocks (factory made) of size 30x20x15 cm or nearest available size confirming to is 2185 part i of 1979 for foundation and plinth with thickness 15cm in: cm 1:6 ( 1 cement :6 coarse sand) etc complete 10 4.11: providing and laying damp-proof course 50mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand (zone-iii) derived from natural sources : 4 graded stone aggregate 20mm nominal size derived from natural sources). 11 5.9.6:centering and shuttering including strutting, etc. and removal of form for:columns, pillars, piers, abutments, posts and struts 12 5.2.2:reinforced cement concrete work in walls (any thickness), including attached pilasters, buttresses, plinth and string courses, fillets, columns, pillars, piers, abutments, posts and struts etc. up tot floor five level excluding cost of centering, shuttering, finishing and reinforcement :1:1.5:3( 1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size derived from natural sources) 13 4.1.6:providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - all work up to plinth level:1:3:6 (1 cement : 3 coarse sand (zone-iii) derived from natural sources : 6 graded stone aggregate 40 mm nominal size derived from natural sources) 14 50.6.1.5:solid block masonry using pre cast solid blocks ( factory made) of size 30x20x20cm or nearest available size confirming to is 2185 part i of 1979 for super structure up to floor two level thickness 20cm and above in: cm 1:6 ( 1 cement : 6 coarse sand) etc complete 15 5.3:reinforced cement concrete work in beams, suspended floors, roofs, having slope up to 15°landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases up to floor five level excluding the cost of centering, shuttering, finishing and reinforcement, with1:1.5:3 (1 cement : 1.5 coarse sand (zone iii)derived from natural sources: 3 graded stone aggregate 20 mm nominal sizederived from natural sources). 16 5.9.5:centering and shuttering including strutting, etc. and removal of form for:lintels, beams, plinth beams, girders bressumers and cantilevers 17 5.9.3:centering and shuttering including strutting, etc. and removal of form for:suspended floors, roofs, landings, balconies and access platform 18 5.9.16.1:centering and shuttering including strutting, etc. and removal of form for:edges of slabs and breaks in floors and wallsunder 20 cm wide 19 5.9.19:centering and shuttering including strutting, etc. and removal of form for:weather shade, chajjas, corbels etc., including edges 20 5.9.7:centering and shuttering including strutting, etc. and removal of form for:stairs, (excluding landings ) except spiral - staircases) 21 5.22.6:steel reinforcement for r.c.c work including straightening, cutting, bending, placing in position and binding all complete upto plinth levelthermo - mechanically treated bars of grade fe-500d or more 22 13.1.1:12 mm cement plaster of mix:1:4 ( 1 cement : 4 fine sand) 23 13.16.1:6 mm cement plaster of mix:1:3 ( 1 cement : 3 fine sand) 24 10.6.1:supplying and fixing rolling shutters of approved make, made of required size m.s. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensile steel wire of adequate strength conforming to is: 4454 - part 1 and m.s. top cover of required thickness for rolling shutters.80x1.25 mm m.s. laths with 1.25 mm thick top cover 25 10.7:providing and fixing ball bearing for rolling shutters. 26 8.31:providing and fixing ist quality ceramic glazed wall tiles conforming to is: 15622 (thickness to be specified by the manufacturer), of approved make, in all colours, shades except burgundy, bottle green, black of any size as approved by engineer-in- charge, in skirting, risers of steps and dados, over 12 mm thick bed of cement mortar 1:3 (1 cement : 3 coarse sand) and jointing with grey cement slurry @ 3.3kg per sqm, including pointing in white cement mixed with pigment of matching shade complete. 27 11.41.2:providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to is : 15622, of approved make, in all colours and shades, laid on 20 mm thick cement mortar 1:4(1 cement : 4 coarse sand), including grouting the joints with white cement and matching pigments etc., complete.size of tile 600 x 600 mm. 28 9.48.1:providing and fixing m.s. grills of required pattern in frames of windows etc. with m.s. flats, square or round bars etc. including priming coat with approved steel primer all complete.fixed to steel windows by welding 29 13.43.1:applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface:water thinnable cement primer 30 13.60.1:wall painting with acrylic emulsion paint of approved brand and manufacture to give an even shade:two or more coats on new work 31 17.7.3:providing and fixing wash basin with c.i. brackets, 15 mm c.p. brass pillar taps, 32 mm c.p. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever require:white vitreous china wash basin size 550x400 mm with a pair of 15 mm c.p. brass pillar taps 32 10.17:providing and fixing m.s. fan clamp type i or ii of 16 mm dia m.s. bar, bent to shape with hooked ends in r.c.c. slabs or beams during laying, including painting the exposed portion of loop, all as per standard design complete. 33 od117395/2025-2026:supplying and fixing pvc door 34 50.17.1.4:supplying and fixing cp health faucet good quality including cost of materials and labour charges etc. complete as per the direction of site engineer-in-charge. 35 17.2.1:providing and fixing white vitreous china pedestal type water closet (european type w.c. pan) with seat and lid, 10 litre low level white p.v.c. flushing cistern, including flush pipe, with manually controlled device (handle lever), conforming to is : 7231, with all fittings and fixtures complete, including cutting and making good the walls and floors wherever required:w.c. pan with isi marked white solid plastic seat and lid 36 17.29:providing and fixing 100 mm sand cast iron grating for gully trap. 37 50.18.9.4.2:providing and fixing pvc pipes includings joints of pipes with one step pvc solvent cement, trenching, refilling & testing of joints complete as per direction of engineer in charge. 32 mm dia 6 kgf/cm2 38 50.18.9.7.1:providing and fixing pvc pipes includings of pipes with one step pvc solvent cement, trenching refilling & testing of joints complete as per direction of engineer in charge. 63 mm dia 6kgf/cm2 39 50.18.9.9.1:providing and fixing pvc pipes includings jointing of pipes with one step pvc solvent cement, trenching, refilling & testing of joints complete as per direction of engineer in charge.110 mm dia 6kgf/cm2 40 50.18.7.3.1:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer- in- charge 25 mm dia 12 kgf/cm2 - internal work - exposed on wall 41 50.18.8.6.2:providing and fixing pvc pipes, fittings including fixing the pipe with clamps at 1.00 m spacing. this includes jointing of pipes & fittings with one step pvc solvent cement and testing of joints complete as per direction of engineer-in-charge. concealed work, including cutting chases and making good the wall etc. 50 mm pipe 6 kgf/cm2 42 13.52.1:finishing with epoxy paint (two or more coats) at all locations prepared and applied as per manufacturers specifications including appropriate priming coat, preparation of surface, etc. complete.on steel work