|
| 1 | Receiving complaints from JE incharge lodged by the user/occupants of electrification nature, rectification of the fault as per the compaint lodged by the user onward KWH meter in respect of main distribution board having switch board, fused, MCB distribution board in sheet metal enclosure, point wiring fixture for light/fan /bell /light or power sockets, metal clad plug socket complete repair to the extend by removing connections from the system, removing faults in (surface /concealed) wiring/ circuits, sunken boxes, Junction boxes, main switches, MCBs/DBs any type of utility light fittings, lamp holders, AC ceiling fan/exhaust fans and other connected fixtures of internal electrification including providing stores such as wires of appropriate size and conductor matching to existing one upto the height of 2 mtr, insulation tape, screws, nuts as per the site requirement to rectify the fault with regard to complaint lodged and refixing of fitting and fixture to their original position as dismentled complete all as directed at site to the entire satisfaction of Engineer -in- Charge.Note : (i) Any complaint which is left out/unattendent 1 days by the electrician by any reasons the same to be communicated to the JE incharge /AGE E/M with reason.(ii) New material/stores provided for completing the job shall be measured and paid for separetely under relevent items of sch 'A'.(iii) Contractor shall provide the all type of T & P to each electrician for attending the internal electric complaints. (iv) Contractor shall provide the complaint register and complaint slip serially numbered in duplicate as per sample.If complaint received online the contractor should provide A4 size paper and printer for printing complaints. The rate of such items included in this items.(v) Any unattended complaints not done in specified time limit. The contractor shall penalty Rs. 200/- on each complaints per day is applicable.(vi) Two complaints will be treated as one complaint in same building/same Quarter on same day. |
| 2 | Supply only in replacement switch piano type 5 Amps one way AC 230 Volts. |
| 3 | Supply only in replacement switch piano type 5 Amps two way AC 230 Volts. |
| 4 | Supply only in replacement of bell push 5 Amps, AC 230 Volts. |
| 5 | Supply only in replacement socket 3/5 pin 5 Amps flush type (Multi purpose) AC 230 Volts. |
| 6 | Supply only in replacement switch/socket combination outlet 3 pin 5 Amps flush type (Multi purpose) piano type AC 230 Volts. |
| 7 | Supply only in replacement switch/socket combination outlet 2 in 1, 3 pin 5 Amps and 15 Amp flush type (Multi purpose) piano type AC 230 Volts. |
| 8 | Supply only in replacement of electronic dimmers, 450W, 250V flush type on the exiting phenolic laminated sheet etc. as reqd. |
| 9 | Supply only in replacement of stepped type electronic fan regulator, flush type on the exiting phenolic laminated sheet etc. as reqd. |
| 10 | Supply only in replacement switch modular type 6 Amps one way AC 230 Volts. |
| 11 | Supply only in replacement switch modular type 16 Amps one way AC 230 Volts. |
| 12 | Supply only in replacement modular type bell push 6 Amps, AC 230 Volts. |
| 13 | Supply only in replacement modular type socket 6 Amps 2/3 pin combined, AC 230 Volts. |
| 14 | Supply only in replacement modular type socket 6/16 Amps 2/3 pin combined, AC 230 Volts. |
| 15 | Supply only in replacement modular type fan regulator, AC 230 Volts. |
| 16 | Supply only in replacement modular white cover plate with frame, 2 module. |
| 17 | Supply only in replacement modular white cover plate with frame, 4 module. |
| 18 | Supply only in replacement modular white cover plate with frame, 8 module. |
| 19 | Supply only in replacement of ceiling rose 65x50mm two to three terminal AC 230 volts complete all as specified. |
| 20 | Supply only buzzer,AC, 230 volts, single phase. |
| 21 | Supply only bell, ding dong, AC, 230 volts, single phase. |
| 22 | Supply only bell multi music type AC, 230 volts, single phase. |
| 23 | Supply only in replacement lamp holder insulated body with back plate batten/angle type for batten fittings. |
| 24 | Supply only in replacement sheet metal enclosures with plug socket single pole and neutral with two pin and earth plug and with one MCB of 20 Amps (SP) complete all as specified. |
| 25 | Supply only in replacement of 30 Watt LED street light fitting with, energy saving and environmental friendly long life LED street light made up of pressure die cast aluminium housing with high efficiency LED as lighting source and lens embedded PC cover having Bottom Opening seperate driver compartment with IP66 protection and impact resistance of IK08, including connecting up with 2/3 core flexible coppper conductor cable, compete all as specified and directed directed by Engineer-in-Charge. |
| 26 | Supply only in replacement cable flexible PVC insulated twin core with copper conductor of size 23/0.0076 |
| 27 | Supply only in replacement cable flexible PVC insulated twin core with copper conductor of size 40/0.0076 |
| 28 | Supply only in replacement plug top 3 pin 5 amps AC 230 volts. |
| 29 | Supply only in replacement plug top 3 pin 15 Amps AC 230 volts. |
| 30 | Supply only PVC connector block two ways AC 230 volts suitable for fan/tube light fittings etc. |
| 31 | Supply only bakelite sheet not less than 3mm thick for mounting of switch sockets, fan regulators, etc. size 100x100mm or PVC rectangular Box of 100 mm x 100mm and 50 mm deep complete with screws and washers, etc. all as specified and directed directed by Engineer-in-Charge. |
| 32 | Supply only bakelite sheet not less than 3mm thick for mounting of switch sockets, fan regulators, etc. size 175x100mm or PVC rectangular Box of 175 mm x 100mm and 50 mm deep complete with screws and washers, etc. all as specified and directed directed by Engineer-in-Charge. |
| 33 | Supply only bakelite sheet not less than 3mm thick for mounting of switch sockets, fan regulators, etc. size 250x200mm or PVC rectangular Box of 250 mm x 200mm and 50 mm deep complete with screws and washers, etc. all as specified and directeddirected by Engineer-in-Charge. |
| 34 | Supply only bakelite sheet not less than 3mm thick for mounting of switch sockets, fan regulators, etc. size 200x150mm or PVC rectangular Box of 200 mm x 150mm and 50 mm deep complete with screws and washers, etc. all as specified and directed directed by Engineer-in-Charge.. |
| 35 | Supply only in replacement MCB SP, 6 to 32 Amps 10 KA single pole AC 230 volts complete all as specified |
| 36 | Supply only in replacement MCB SPN 6 to 40 Amps 10 KA AC 230 volts complete all as specified |
| 37 | Supply only in replacement of rigid non metalic PVC conduit conduct including junction boxes terminal, tees bends, elbows reducers, bell mouth tube ends and fixing accessories such as complete, lock nuts, saddles pipe hook etc of size 20mm dia. complete all as specified and directed by Engineer in charge. |
| 38 | Supply only in replacement twin sub main cable with 2 x 4 Sqmm multistrand PVC insulated unsheathed copper conductor PVC cable including contineous earth wire 1 x 4 Sqmm copper conductor insulated unsheathed complete all as specified and directed by Engineer in charge as following:-(a) In PVC conduit(20mm) |
| 39 | All as per item No 38 here-in-befoe (b) In PVC casing caping(25mm) |
| 40 | All as per item No 38 here-in-befoe but 2 x 6 sqmm copper cable as a sub main and 1 x 6 sqmm cable as a earth lead complete all as specified and directed by Engineer in charge.(a) In PVC conduit(20mm) |
| 41 | All as per item No 39 here-in-befoe (b) In PVC casing caping(25mm) |
| 42 | Point wiring with 1.5 Sqmm (nominal area) copper conductor cable (Multi strand) PVC insulated and unsheathed in and incl PVC casing caping of adequate size with 3mm thick plastic laminated sheet cover of adequate size for one light or one fan /05 amp socket /bell controlled by one switch incl 1.5 Sqmm (nominal area) copper conductor cable (multi strand) PVC insulated and unsheathed with colour code earth wire to common earth dolly complete all as specified. |
| 43 | All as per srl item No 41 here in before but with 2.5 sqmm copper conductor cable (multistrand) complete all as specified and directed by Engineer in charge. |
| 44 | Supply only in replacement 20 Watt LED Tube Light (4 feet) Ultra bright, (single side connection) with very high efficacy & THD <15% best suited for installation in existing tubelight luminaire with G13 lamp holders to give glare free light. |
| 45 | Supply only in replacement of sheet metal enclosure (Factory made) double door shutter type for distribution board (when MCBs are to be used) single pole and neutral 240 volts 8 way with 200 Amps rated busbar all as specified |
| 46 | All as per srl item No 44 here in beflore but 4 way SPN with 200 amps rated bus bar all as specified |
| 47 | All as per srl item No 44 here in beflore but 4 way TPN 415 volts all as specified |
| 48 | Supply only in replacement MCB TPN, 415 Volts, 63 Amps all as specified. |
| 49 | Supply only in replacement PVC casing caping and fixing accessories such as complete, lock nuts, saddles hook etc of adequate size complete all as specified and directed by Engineer in charge. |
| 50 | Supply only in replacement of 18Watt LED 6500 K (PRIDE PLUS) inverter LED batten with square profile and polycarbonate channel. Lithium Ion battery with charging time 8hours-10 hours and back up time upto 4 hours mounted on square box of suitable size connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete. |
| 51 | Supply and fixing in replacement spring loaded rotary type bipin holder suitable for LED tube light fittings. |
| 52 | Supply only in replacement invertor LED lights fitting 1x 10W (2 Ft), 220V, AC, LED batten with square profile and polycarbonate channel. Lithium Ion battery with charging time 8-10 hours and back up time upto 4 hours., mounted on square box of suitable size including connecting up with three core flexible copper conductor cable of suitable size from ceiling rose complete. |
| 53 | Supply only invertor LED lamp 8/9 watt capacity complete all as specified and directed by Engineer-in-Charge. |
| 54 | Supply only invertor LED lamp 12 watt capacity complete all as specified and directed by Engineer-in-Charge. |
| 55 | Supply only in replacement of 20 Watt LED street light fitting luminaire, energy saving and environmental friendly long life LED street light made up of pressure die cast aluminium housing with high efficiency LED as lighting source and lens embedded PC cover having Bottom Opening seperate driver compartment with IP66 protection and impact resistance of IK08, including coneecting up with 2/3 core flexible coppper conductor cable, compete all as specified and directed directed by Engineer-in-Charge. |
| 56 | Supply only in replacement of LED bulkhead 10 watt 220 volts AC with cast aluminium housing,polycarbonate diffuser IP65 complete with all accessories internally pre-wired and including connecting up with twin core twisted flexible copper conductor cable with suitable size. |
| 57 | M&L earthing complete with galvanized steel earth plate electrode 60cm x 60cm x6.0 mm thick, burried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of the plate not less than 1.5 metre below normal ground level, connected to galvanized earth lead wire 4.0mm dia Protedcted by light GI Pipe 20 mm dia and 15 dia med grade for watering pipe and connected by means of bolts, nuts, check nuts and washers of galvanized iron or steel, iron funnel,Iron pit cover and chamber all as shown in electrical plate No. 3 connected to earthing test point including testing on completion complete all as specified and directed directed by Engineer-in-Charge.. Please Enable Macros to View BoQ information |
