|
| 1 | Total of Schedule-A |
| 2 | Total of Schedule-B(Buy Back) OEW-2177 APPENDIX- 3A PROFORMA FOR STATEMENT OF MINOR DEVIATIONS (Refer Clause C 2.2(d) and C 15.1 of ITT) 1. The following are the particulars of minor deviations from the requirements of the Tender Document: Sr. No Clause Deviations Price reduction for each deviation/s Note : 1. The Tenderer shall indicate price reduction against each deviation in Appendix-3A of BOQ. This price is the price which the tenderer shall reduce from this tender price if deviation(s) is/are accepted by the Employer. 2. Where there is no deviation, the statement should be returned duly signed with an endorsement indicating ‘No Deviations’. In case, Performa of deviations is not submitted or submitted as blank, it will be construed that the tenderer has not proposed any deviations from tender documents. 3. It shall be noted that in case Nil/Zero/NA Price quoted by Tenderer in Appendix-3A then it shall mean that contractor has quoted same price for deviation and undeviation bid. 4. If the tenderer proposes deviations in tender documents, and/or any other terms and conditions of the tender, other than in this Appendix, it will have no effect. Signature of authorized signatory On behalf of Tenderer Preamble OEW-2177 |
| 3 | The bill Quantities shall be read in conjunction with Notice Inviting Tenders, Instructions to tenderers, General and Special Conditions of Contract, Employers Requirements & Technical Specification and other relevant documents |
| 4 | BoQ1 consists of Schedule ‘A’ (SITC of LBT) & Schedule ‘B’ (Buy Back Items). The rates and prices to be tendered in the unit Priced Bill of Quantities of Schedule ‘A’ & Schedule ‘B’, are for completed and finished items of works and complete in all respect. |
| 5 | Tenderers shall quote their offer in Indian Rupees (₹) only. |
| 6 | Tenderers shall quote their offer in Indian Rupees (INR) only. Tenderers are required to be quoted percentage (%) Excess/Less/At par for schedule-A and Schedule-B in figures in the appropriate highlighted cells in the BoQ1 sheet. All the quoted rates will be deemed to include Duties, Taxes, Octroi, Royalty etc., cost of all plants, labour, supervision, materials, transport, all temporary works, erection, maintenance, utility identification, contractor’s profit and establishment/ overheads, together with preparation of design and drawings, all general risks, insurance liabilities, compliance of labour laws and obligations set out or implied in the contracts. For taxes and duties refer clause C2.5 of ITT & clause 10 of SCC. |
| 7 | The price offer in the BOQ shall be given without considering any deviation mentioned in Appendix-3 of FOT i.e. price in the box shall be quoted as per tender conditions without any deviation. |
| 8 | If the tenderer fails to quote percentage against BOQ item, the tender may be treated as incomplete and non- responsive and shall be rejected. |
| 9 | Errors will be corrected by the employer for any arithmetical errors in computation or summation as per contract conditions. |
| 10 | The Financial Proposal (as per BOQ) shall be uploaded online on the website http://etenders.gov.in/eprocure/app. The rates/ percentages shall be quoted in the excel file provided in the bid documents. The tenderer shall download the excel file and quote percentage in figures against BOQ amount in the appropriate highlighted cells in Excel sheet namely \\"BoQ1\\". After quoting their rates the excel file shall be uploaded accordingly. The rates shall not be offered/quoted elsewhere in the technical submission/ tender submission. |
| 11 | Bill of Quantities comprises of items/works to be executed as per Employer’s Requirements. |
| 12 | The work executed against all the BOQ as detailed in tender document would be paid as per clause 13 of Special Conditions of Contract (SCC). Please Enable Macros to View BoQ information DELHI METRO RAIL CORPORATION LIMITED BOQ Contract: OEW-2177 – “Replacement of LBT (Lighting Bus Trunking) and associated electrical work over L-1” Sl. No. Discription Unit QTY. Rate (ex. GST) Amount Schedule-A (SITC of LBT) |
| 13 | Supply, installation & testing of 25A, Copper Lighting Bus Trunking System in easy detachable and convenient assembly suitable for 415 +/- 10% volts, 3 phase +Neutral , 8 wire, 50 Hz AC system with CU bus conductors of minimum 2.5 sqmm section and stainless steel/ hot galvanised steel enclousre /extruded Aluminium housing enclousre, with tap off provision every 0.5 meter. The lighting Bus trunking shall be conforming to latest IEC standards 61439- 6 & 1. It shall be with IP-55 protection, halogen free and fault level withstand capacity of 2.5 KA min for 0.1 sec (Icw). The bus trunking shall be complete with accessories like supporting clamps for installation at site, fixing clamps for luminaries etc.Note:- Work is to be executed in non revenue hours only a Straight feeder 25A (3 Mtr Length) Nos 1440.0 9620.0 13852800.0 b End Feed Unit Nos 96.0 4900.0 470400.0 c End Covers Nos 96.0 250.0 24000.0 d 10/16A single phases tap off boxes with fuse and indication Nos 3120.0 950.0 2964000.0 |
| 14 | Dismantling of existing different capacities and type of light fitting from wall/ ceiling/ fabricated beam/ stairs upto heeight of 30 feet.Note:- Work is to be executed in non revenue hours only. Luminaries should be removed in good condition from LBT, so that dismantled luminaries may be installed after installation of New LBT |
| 15 | Dismantling of existing Lighting Bus Trunking system including wiring and associated accessories etc complete in all respect or as per requirement of site conditionNote:- Work is to be executed in non revenue hours only. |
| 16 | Fixing of different size and capacities of light fitting from wall/ ceiling/ fabricated beam/ stairs upto the height of 30 feet with suitable size of nut bolts if required and other related accessories complete in all respectNote: - Work is to be executed in non revenue hours only. |
| 17 | Supply, laying. Testing and commissioning at the site work of 600/ 1000V grade copper conductor, XLPE insulated, armoured, Low smoke Zero Halogen, fire resitant/ survival type cables conforming to BS 7846 and technical specification (on existing trays/ walls/ columns/ indoor/ trenches with suitable clamps, sadles, hooks, bolts etc) of the following size: -Note:- Work is to be executed in non revenue hours only. a 4x10 Sqmm Mtr 1000.0 700.0 700000.0 b 3x10 sqmm Mtr 1000.0 580.0 580000.0 |
| 18 | suplying and providing terminations conforming to technical specifications of XLPE, fire survival cables armoured/ unarmoured cables (as per technical Specifications) of sizes given below including the cost of supplying, fixing and crimping tinned CU lugs, double compression flame proof brass glands, insulation taps etc. This also includes making holes in gland plate complete as per specifications and as requiredNote:- Work is to be executed in non revenue hours only. a 4x10 Sqmm Nos 96.0 700.0 67200.0 b 3x10 sqmm Nos 96.0 580.0 55680.0 |
| 19 | Supply, laying. Testing and commissioning of 3 core 2.5 sqmm, copper wire, from Tap off boxes to lighting fixture including connections, earthing etc complete as required (LSZH cu wire as per BS 50525-41)Note:- Work is to be executed in non revenue hours only. a 3C x 2.5 sq mm Cu Conductor Mtr 3500.0 380.0 1330000.0 Total amount of Schedule-A (Exclusive of GST) 24052080.0 GST @ 18% 4329374.4 Total amount of Schedule-A (Inclusive of GST @ 18%) 28381454.4 Schedule-B (Buy Back Items) |
| 20 | Buy back of old lighting bus truncking system including wiring and assocaied accessories Total amount of Schedule-B (Exclusive of GST) 40000.0 GST @ 18% 7200.0 Total amount of Schedule-B (Inclusive of GST @ 18%) 47200.0 Grand total amount of Schedule-A & B (Exclusive of GST) 24012080.0 Grand total amount of Schedule-A & B (Inclusive of GST @ 18%) 28334254.4 |