Tender For Providing 33Kv Ht Cable From Avr To Transformer At Gnida Office Building, Sector Kp-Iv, Greater Noida. - Supply, delivery, laying testing & commissioning of 33KV (E), XLPE cable having compacted circular staranded aluminium conductor, conductor screening of extruded semi conducting compound, cross linked polythylane (XLPE), insulation screening of the extruded semin conducting compound followed by copper tape, cores laid up, taped PVC inner sheath, single layer of steel strip armouring, overall PVC outer sheath conforming to IS: 7098 (Part-amendments) for following mentioned sizes. It should be operational at 11 KV, 50 Hz. AC system in ground at a depth of 1200 mm below ground level over a cushion of 75 mm thick sand alround and protected with bricks on sides and top on surface the cable run shall be fixed on M.S. clamps etc of suitable size or as directed by the E/l. Complete in all respect. The price are inclusive of all earth work such as digging, back filling, supply & spreading of good earth all around the cable, supply & providing cable identification markers. The installation should be complete in all restion against standard Low Voltage Directive & Protective EquiMake CCI, Gloster, Asian, Universal, Nicco, ICL, Diamond, Havells & KEI make.(GNIDA SOR-2024/03) 3 (a) 3CX185 Sqmm. 4 Supply, Delivery, Installation, Testing & Commissioning of 33KV, following type cable termination kit complete in all respects as required for proper completion of work. (make Raychem, CCI, Frontec) (GNIDA SOR-2024/12) 5 a. 3CX185 Sq.mm. (indoor type) 6 S/L of 160mm dia HDPE pipe for drawing of power cable across the road by drilling of 180mm dia at 1.0mtr. below the road level thereby doing the work of providing HDPE pipe by Trenchless method PE-63/PN-8, complete in all respect as per direction of E/I (GNIDA SOR-2024/25) 7 S/F of HDPE pipe 160mm dia. PE-63/PN-4 including required material, T&P etc. complete in all respect as per direction of E/I (GNIDA SOR-2024/21) 8 Supply and Installation of Perforated type trays Prefabricated 2.5mm G.. (Hot Dip Galvanised), 75mm flange height with all accessories such as coupling plates, bends, tees, reducers, coupling nut-bolts etc. of following width. The cost of installation shall include connection, bolting, cutting, etc. The supporting steel for cable trays shall be painted type and Cable trays, accessories and covers shall be painted with one shop coat of red oxide zinc chromate primer and two site coats of aluminium alkyd paint. Complete in all respects as per direction of E I/c. (GNIDA SOR-2024/55) 9 300mm width 10 Supplying, installing by suspension on ceiling. testing and commissioning of following capacity Sandwich Type Rising Mains for use on 3 phase 4 wire 415 volts, 50Hz A.C. supply with metal clad enclosure having IP-54 rating after fixing the tap off boxes and all accessories, made of 1.6mm thick steel sheet duly powder coated in convenient sections complete with 4 Nos aluminium bus bars having current density of 130 A/ sq cm at nominal current rating, necessary joints, elbow joints & expansion joints and bends, fire barrier at each floor, provision of tapping at every metre, adopter box and copper flexible for joints, continuous earthing with 2 Nos aluminium strip of suitable size (one on each side) including, G.I. clamping brackets, suspenders, angle iron bracket, steel fasteners, connecting to earthing system etc. as required 11 3200 A 50 KA TSC for 1 sec (DSR-2018/3.13.10) 12 Labour Cess and GST will be paid extra as per govt. orders
