Tender For Special Repair Of Sadat Pyarepur Mirjapur Link Road To Darwal Link Road Including 115M Cc In Abadi Portion - WBM Grading 3 Providing laying spreading and compacting stone aggregate of specific sizes to Water bound Mcadam specification including spreading in uniform thichness hand packing, rolling with smooth wheel 80-100 kN in stages to proper grade and camber, applying and brooming stone screening to fill up the interstices of coarse aggregate, watering and compacting to the required density Grading-3 as per Technical Specification. Clause 405. (Including all material, T&P, labour cess etc. but excluding G.S.T.) 2 Prime Coat : Low porosity Providing and applying primer coat with bitumen emulsion (SS-1) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.70kg/sqm using mechanical means as per Technical Specification Clause 502 (Including all material, T&P, labour cess etc. but excluding G.S.T.) 3 Tack Coat Providing and applying tack coat with V.G-10 using bitumen pressure distributor @ 0.30 kg per sqm on the prepared granular surface treated with primer & cleaned with Hydraulic broom as per Technical Specification Clause 503 (Including all material, T&P, labour cess etc. but excluding G.S.T.) 4 20mm thick Open Graded Premix Carpet using Bituminous (penetration grade) Binder : Providing, laying and rolling of Open-gradedpremix surfacingof 20 mm thickness composed of 13.2 mm to 5.6 mmaggregates either using penetration grade bitumen or emulsion to required line grade and level to serve aswearing course on a previously prepared base. including mixing in a suitable plant , laying and rolling with a smooth wheeled roller 8-10 tonne capacity, and finishing to required level andgrade to be followed by seal coat of either Type A or Type B or Type C as per Technical Specification Clause 508 (Including all material, T&P, labour cess etc. but excluding G.S.T.) 5 Seal Coat Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall usingType C, as per Technical Specification Clause 510 (Including all material, T&P, labour cess etc. but excluding G.S.T.) 6 Cement Concrete Pavement Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars, near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days, using curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification Clause 1501 7 Construction of subgrade and earthen shoulders construction of subgrade and earthen shoulders with approved material obtained from R.O.W. with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of table 300.2 as per Technical Specification Clause 303.1
