|
Tender For Request For Proposal (Rfp) For Operational And Routine Maintenance Activities At R-Cat, Jaipur- 1 Providing & Fixing of IP-20 LED Recessed / Surface Mounted, Round / Sqaure SMD Mid Power LED Downlight with power coated die-cast aluminum housing with UV Stabilized non yellowish Diffuser with BIS complience 2.5 KV surge protected Isolated driver, with Short & Open circuit protection, having efficiency > 85% . System Lumen efficacy of ≥ 110 lm / watt, THD < 10 % , Pf.≥0.95, CRI >80, life time of minimum 50000 Burning Hours with , 70% of intial Lumen maintaned till life ends , CCT 3000°K / 4000°K/ 5700°K /6000°K/6500°K (As per ANSI Bin) , maximum power consumption should not more than the specified rating and Fixture shall be of BIS standard and trade mark certificate ( T.C.). Manufactures Word Mark/ Name Engraved/ Embossing/ Screen printing on housing. 2 Minimum lumen output 1600 lm 3 Supply & Stacking good soil of earth at site complete including loading unloading & Transportation etc. Soil for gardening work and Soil Filling 4 Supply of dry manure Vermi compost including loading unloading, transportation & stacking at site. for gardening work 5 Supply of insecticides & Pesticides at store in dust/liquid form complete.Cholorophyriphos 20 Ec. 6 Replace of existing urinal sensor Battery Cell of Duracell make. 7 Supply and installation of semi unitised structural glazing with PVDF Coated aluminim profiles designed for 1.5 kPa wind pressure. The rate is inclusive of required MS hot dip galvanised brackets, weather silicone DC789, structural silicone DC 983, SS304 screws, smoke seal, flashing,glass specification as mentioned, openable vents and spandral insulation as specified. Vision Area- 24mm DGU (6+12 a/s+6) HS glass 8 Providing and applying of acrylic emulsion paint finish to walls, blocked partitions, and plasterboard ceiling surfaces of approved shade, texture. Existing wall and ceiling surfaces to be prepared by scraping away any loose particles, dust, etc. by washing and scrubbing and 1 coat of primer approved by manufacturer applied. The wall surfaces are then smoothened using putty approved by the manufacturers. Surfaces are then sandpapered to achieve a smooth finish and two or more coats of paint included waterproofing compound are applied as per manufacturers specification. 9 Providing and laying water proofing treatment to vertical and horizontal surfaces of depressed portions of W.C., kitchen and the like consisting of : i) Ist course of applying cement slurry @ 4.4 Kg/sum mixed with water proofing compound conforming to IS 2645 in recommended proportions including rounding off junction of vertical and horizontal surface.ii) IInd course of 20mm cement plaster 1:3 (1 cement: 3 coarse sand) mixed with water. proofing compound in recommended proportion including rounding off junction of vertical and horizontal surface..iii) IIIrd course of applying blown or residual bitumen applied hot at 1.7 Kg per Sq.mt. of area.iv) IVth course of 400 micron thick PVC sheet .(Overlaps at joints of PVC sheet should be 100 mm wide and pasted to each other with bitumen @ 1.7 Kg/Sq.mt.) 10 Providing and fixing in position bitumen impregnated fiberboard confirming to IS: 1838 in expansion joints including the cost of primer sealing compound. 25mm thick
|