Providing And Fixing Safety Equipments To High Masks=1 Digging Of Trench Of 0.6M Deep X 0.50 Mtr Wide Refilling The Trench To The Required Ground Level And Consolidating Etc., Complete. ( As Per Civil Sr Ksrb I-2, P-7 ) Asphalt Cutting 2 Supply And Lay-Karnataka

Providing And Fixing Safety Equipments To High Masks=1 Digging Of Trench Of 0.6M Deep X 0.50 Mtr Wide Refilling The Trench To The Required Ground Level And Consolidating Etc., Complete. ( As Per Civil Sr Ksrb I-2, P-7 ) Asphalt Cutting 2 Supply And Laying Double Walled Corrugated ( Dwc ) Hdpe Pipe Including All Necessary Connectingsockets / Couplings / Tees / Bends / End-Caps Of Same Materials In Existing Trench As Per Is 14930 Part -Ii Suitable For Drawing Underground Cables.50Mm Od / 38Mm Id 3 Supplying Of 1.1 Kv Lt Ug Cable Having Aluminum Conductor Pvc Insulated, Extruded Inner Sheathed, Galvanized, Steel Strip ( Except 2Cx10sq.Mm Wire Armoured ) Confirming To Is-3975:1990 ( No. Of Strip Indicated In Gtp ) & Extruded Pvc Outer Sheathed Armoured Cable With Specified Is-1554 Part-1:1988 & Confirming To Gtp Of Group-A.3.5 Core 25 Sqmm 4 Labour Charges For Laying Of 1.1 Kv Class Ug Cable In Existing Trench Gi Pipe / Stoneware Pipe / On Wall / On Pole As Required.In Existing Trench / Duct.25 Sqmm To 75 Sqmm 5 Supplying And Fixing L.T. Cast Iron Pot Heads Suitable For 1.1 Kv Class Ug Cable Filled With Necessary Bitumen / Insulating Compound Complete With Terminals, Clamps, Bolts, Nuts And Washers Etc.25Sqmm 6 Supplying And Fixing Of Heavy Duty Cable Glands Suitable For Ug Cable Of 1.1 Kv Class ( Metal Only ) 25Mm Dia 7 Supplying Tinned Copper Lugs And Crimping And Wiring To Terminal Point For Wire Of The Following Sizes.25 Sqmm Long Barrel 8 Supplying, Fixing, Wiring, Earth Electrode For Grounding Conduits, I.C. Cutouts And Other Equipments On The Meter Board Using 40Mm Dia 2.90Mm Thick Gi Pipe 2.5 Mtr Long Buried In A Pit … The Pit Should Be Filled With Equal Proportion Of Salt And Charcoal 150Mm All-Round The Pipe To Complete Depth. The Connection From The Pipe To The Conduit Etc., Is To Be Established Through Gi Wire Of Size As Per Isi Specification 7.3.3. Of Is 732 Using 12Mm Dia Bolts, Nuts, Washers And Check Nuts Etc., The Pipe Shall Have 16 Through Holes Of 122 Mm Dia 9 Supply And Installation / Fixing / Provision Of Pole Box With Hrc Fuse / Mcb Provision And Suitable Connector / Terminal For 3 Ph / 1 Ph Connections With Loop-In & Loop-Out Terminals For 10 Sqmm / 25 Sqmm 3.5 C Al / Ar / Cu / Ar Cable And Branch Out 2.5 Sqmm 2 Core Al / Cu Pvc Insulated Cable, Enclosed In A Thermoplastic, Polystyrene Enclosure, Which Should Be Shock Proof, Safe, Ip65 ( Weather Proof ) , Rust Proof, Dust Proof, Water Proof Having Internally Embedded Gasket With Provision For Cable Entry Through Ip65 Thermoplastic, Polyamide Glands And / Or Grommets.200Mmx200mmx98mm 10 Fabricating Supplying And Mounting Ms Box Made Out … Swg Suitable For Floor / Wall Mounting, Fully Weather Proof With Provision For Better Heat Dissipation, Provided With Hinged Front Cover, Equipped With Tamper Proof Locking Arrangements, With Suitable Size Clamps With Necessary Cable Entry Pipe With Gland And Box Should Be Finished With 2 Coats Of Red Oxide Primer Paint And Finally Finished With Approved Colour Enameled Metal Paint Etc., Complete.14Swg 11 Panel Box Angle Stand Supplying And Fixing Angle Iron Frame Work Fabricated Out Of M.S .Angle …..With Bolts Washers Etc Etc And Painted With 2 Coats Of Red Oxideand Then Two Coats Of Approved Paint ( 32.9A ) C ) 75X75xx6mm 12 Supplying And Fixing Moulded Case Circuit Breaker ( Mccb ) Over The Existing Wood / Panel Board Using Necessary Screws, Bolts, Nuts And Wiring Complete. Protection Of Overload And Short Circuit With Thermal Magnetic / Micro Processor Release And Earth Fault As Per Is-13947. ( Icu = Ics ) Four Pole 100Amps 25Ka. 13 Supplying And Fixing Hrc Fuse Units Base On Existing Switch / Panel Board.63A To 125Amps 14 Supplying And Fixing Hrc Fuse Link On Existing Switch Fuse Base With Watt Loss As Per Is-13703.Up To 63Amps 15 Supply And Fixing Polished Wood Board Made Of Not Less Than 15Mm Thick Plank On Both Sides Of Not More Than 2 Pieces And Fixing The Same To The Wall Using Tapered Inverted Wooden Plugs Screws.20X20X2.5 16 Supplying Of Tpst With Rewirable Porcelain Channels In Sm Enclosure. Made Out Of 14 Swg Powder Coated Paint Of Approved Colour.32Amps 17 Providing And Fixing Single Phase Autoswitch Timer Providing And Fixing 3 Phase 4Pole Contactor 40Amps

INR 500 /-

INR 10500.0 /-

INR 4.20 Lakhs /-