Irrigation And Public Health Department has published Retrofitting To Providing Lwss To Pc Habitation Of Lwss Leda Slapper & Wss Dasehra In Gp Bairkot Kathyaun & Dashera In Tehsil Balh Distt. Mandi ( Hp ) . ( Sh:- C / O Pump House Cum Chowkidar Room Below 50 Bhp = 1 No., C / O Sumpwell Cum Storage Tank O. Submission Date for this Tender is 06-08-2021. Water Supply Project Tenders in BAGGI Himachal Pradesh. Bidders can get complete Tender details and download the document.
Sl. No. | Item Description |
1 | Excavation in foundation,trenches up toall depths in all classification of earth work such as pick work,jumper work,saturated soil including bailing and pumping out water, blasting soft/hard rock or chiseling soft/hard rock where blasting is prohibited in all lifts including trimming & dressing of sides, levelling of beds to correct grade i/c shoring/ strutting,planking, timbering & dewatering wherever required, stacking theuseable of unuseable material/ soilseparately &after excavated soil clear from the edge of excavation returning the excavated soil after laying jointing testing of pipes in trenches in 15 Cm layers including consolidating of each deposited layer by ramming & watering & then disposing of all surplus Excavated soil/unusable material as directed with in all leads & lifts including restoration of unmetalled surfaces to its original condition & including cost of diversion for traffic,night signals, fixing caution boards, crossing over trenches for access to houses, fencing etc. complete in all respects with in all leads & lifts as per the entire satisfaction & directions of Engineer- in- charge. |
2 | Providing & laying cement concrete 1:6:12(1:cement :6 sand:12 graded stone aggregate 40 mm nominal size) and curing complete excluding cost of form work in foundation and plinth including carriage of material within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
3 | Providing and laying cement concrete 1:3:6 (1 cement:3sand:6 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work in foundation and plinth within allleads and lifts in all leads and lifts as per the direction and satisfaction of Engineer-in-charge. |
4 | Providing and laying Reinforced cement concrete work 1:1.5:3 (1cement: 1.5 sand : 3 gradedstone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in: |
5 | Foundation & plinth complete in all respect within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
6 | Walls ( any thickness but not less than 0.10m thicknes) including attached butteresses, pillaster plinth and string courses etc. from top of foundationlevel upto floor two level within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
7 | Providing and laying Reinforced cement concrete work 1:2:4 (1cement: 2sand : 4 gradedstone aggregate 20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work in: |
8 | Suspended Floor roofs, landing and shelves and their support balconies, beams, girders, bressumers and contilever complete in all respect within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
9 | Random rubble masonry/polygenal rubbe masonry ( un-coursed/broght to courses) with hard stone of approved quality in foundation and plinth including levelling up with C.C 1:6:12(1cement:6 sand :12 graded stone aggregate 20mm nominal size) in CM 1:6(1cement:6sand) complete in all respect within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
10 | Brick work using common burnt clay building bricks (Ist class) in super structure above plinth level upto floor two level in cement mortar 1:6(1cement:6 sand ) within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
11 | Half brick masonary using common burnt clay building bricks (Ist class) in super structure above plinth level upto floor two level in cement mortar 1:4(1cement:4 sand ) within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
12 | Providing 40 * 3 mm iron hold fast 40 cm long including fixing to frame with 10 cm dia bolts, nuts and wooden plugs and embending in c.c. block 30*10*15 cm 1:3:6 ( 1 cement:3 sand: 6 graded stone aggregate 20 mm nominal size within all leads and lifts as per the direction and satisfaction of Engineer-in-Charge. |
13 | Providing form work with steel plates 3.15 mm thick welded with angles iron in frame 30 x 30 x 5 mm so as to give a fair finish including centering shuttering struting and propping etc. with wooden battens and ballies height of propping and centering below supporting floor to ceiling not exceeding 4 meters and removal of the same for in-situ- reinforced concrete and plain concrete in:- |
14 | Beams, cantilevers, girders & lintels Sides and soffites of beams beam haunchings, cantilevers, bresummers and lintels not exceeding 1mtr in depth in all heights from floor complete in all respect i/c all leads and lifts. |
15 | Flat surfaces such as soffits of suspended floor, roofs, landing and the like complete in all respect complete in all respects as per the directions and best satisfaction of the Engineer-in-charge. |
16 | Edges of slab and breaks in floor and walls under 20cm wide complete in all respect including all leads and lifts. |
17 | Vertical surface such as wall (any thickness) partition and the like including attached pillasters, butresses, etc. plinth and string course complete job in all respects with inall leads and lifts as per the direction and best satisfaction of Engineer-in-charge. |
18 | Providing Mild steel/Tor steel reinforcement for RCC work including bending, binding and placing in position complete in all respect within all leads and liftsas per the direction and satisfaction of Engineer-in-Charge. |
19 | Cement pointing on brick work with cement mortar 1:4(1cement:4sand) complete in all respect within all leads and liftsas per the direction and satisfaction of Engineer-in-Charge. |
20 | Flush pointing complete in all respect within all leads and liftsas per the direction and satisfaction of Engineer-in-Charge. |
21 | Stone soling under floor tightly hand packed complete in all respect within all leads and liftsas per the direction and satisfaction of Engineer-in-Charge. |
22 | 6mm cement plaster to ceiling in Cement mortar 1:3(1cement:3sand) in foundationcomplete in all respect within all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
23 | 20 mm cement plaster in single coat on rough side of brick/concrete stone walls for interior plastering up to floor two levels including arrises, internal rounded angles, chamfers and/or rounded angles not exceeding 80 mm in girth and finished even and smooth in cement mortar 1:6 (1 cement:6 sand) complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
24 | Precast terrazzo tiles 20mm thick with marbal chips of specified sizes laid in floors on a bed of 25mm average thickness of cement mortar 1:6(1cement:6 sand) jointed with neat cement slurry mixed with pigment to match the shade of tiles including rubbing and polishing complete with tiles of shades Silver gray complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
25 | Providing and fixing MS grills of required pattern in MS frames of windows etc with MS flat welded with wire mash complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
26 | Providing wood work in frames of door, windows and clerestorey windows and otherwrought framed and fixed in position in 2nd class Deodar wood, complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
27 | Providing and fixing panneled glazed or panelled and glazed shutters for doors, windows and clerestory windows,including black enamelled iron butt hinges with necessary screws. 40 mm thick.2nd class deodar wood complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
28 | Distempering dry distemper of approved brand and manufacturer( Two coats) and of required shade on undecurated wall surface to give an even shade over and including primer coat of whiting after thoroughly brushing the surface free from mortar droppings and other foreign matter including preparing the surface even and sand papered smoothcomplete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
29 | Applying priming coat on new wood and wood based surfaces after and including preparing the surface by thoroughly cleaning oil,greese,dirt and other foreign matters,sand papering and knotting.Ready mixed paint brushing wood primer pink complete in all respect with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge. |
30 | Painting two coats(excluding priming coat)on new wood and wood based surfaces with ready mixed paint brushing to give an even shade including cleaning of all dirts,dust and other foreign matter sand papering and stopping with paint other than white with in all leads and lifts as per direction and best satisfaction of Engineer-in-charge.. |
31 | Providing and fixing Aluminium sliding door bolts anodized colour and shade with bolts and nuts screws etc complete with in all leads & lifts as per direction and best satisfaction of Engineer-in-charge. (250x16mm) |
32 | Providing and fixing Aluminium Tower bolts anodized colour and shade with bolts and nuts screws etc complete with in all leads & lifts as per direction and best satisfaction of Engineer-in-charge. (250x10mm) |
33 | Aluminium Tower bolts (150x10mm) |
34 | Providing and fixing Aluminium Handles anodized colour and shade with bolts and nuts screws etc complete with in all leads & lifts as per direction and best satisfaction of Engineer-in-charge. Size- 125mm |
35 | Providing Plinth protection 50 mm thick in cement concrete 1:3:6 (1 cement:3 sand:6 graded stone aggregate 20 mm nominal size) complete with in all leads & lifts as per direction and best satisfaction of Engineer-in-charge. |
36 | Providing and fixing SFRC manhole cover and frame confirming to IS 12592(Part-I) with latest ammendment 500mm dia medium duty within allleads and lifts in all leads and lifts as per the direction and satisfaction of Engineer-in-charge. |
37 | Providing and fixing CI cowl 100mm dia complete within allleads and lifts in all leads and lifts as per the direction and satisfaction of Engineer-in-charge. |
38 | Providing and fixing cast iron ventilating pipe of 100 mm diawithin allleads and lifts in all leads and lifts as per the direction and satisfaction of Engineer-in-charge. |
39 | Providing scouring arrangement with 65mm dia sluice valve complete within allleads and lifts in all leads and lifts as per the direction and satisfaction of Engineer-in-charge. |
40 | Laying, jointing & testing of GMS tubes in trenchesincluding tube fitting complete (Earth work to be measured and paid for seprately) complete in all respects with in all leads & lifts as per the entire satisfaction & directions of Engineer- in- charge. |
41 | 65mm dia for inlet, outlet and overflow |
Copyright © 2024 · All Rights Reserved. Terms of Usage | Privacy Policy
For Tender Information Services Visit : TenderDetail