supply of Swing Hammer Type Cane Fibrizer , Swing Hammer Type Cane Fibrizer , Design, Approval Of Design & Drawing, Fabrication And Supply Of New Swing Hammer Type Cane Fibrizer Suitable For 2500 Tcd Capacity Cane Milling Plant With Erection And Commissioning At Site, Having Following Specification :- , (I) Swing Diameter – 1875 Mm (Existing) , (Ii) Nos Of Hammer – 72 Nos , Hammer Shank Wight – 18 Kgs Each , Rotor Shaft Length – 3735 Mm , Moc Of New Shaft – 45 C8 Forged , New Shaft Must Be Forged And Duly Tested Ultrasonically With Test Report , Shaft Diameter – 350 Mm , Existing Prime Moovers – 500 Hp×740 Rpm – 01 Nos , 400 Hp×740 Rpm – 01 Nos , Replacable Domite/High Fibre Tip Size – 90×90×60 Mm , Domilte Tip Type – ‘M’ Type , Bearing Centre Distance – 2480 Mm , Rotor Assembly Hub To Hub Length – 1520 Mm (Existing) , Side Disc Thickness – 40 Mm , Intermediate Disc Thickness – 36 Mm , Intermediate Distance Spacers – M.S. Fabricated Solid Type In Is: 2062 Quality Mild Steel , Wrap Angle Of Anvil Plate - 1600 (In Two Segments) , Existing Bearing – 23144 Kc3 , Proposed Bearing – 23152 Kc3 , Existing Shaft Bearing Journal – 200 Mm , Proposed Shaft Bearing Journal – 240 Mm , Hood Side Plate – 16 Mm Thick (Is: 2062 Mild Steel) , Fly Wheel Hub Width – 185 Mm , Plumber Block – Fabricated Type Suitable For Bearing No 23152 Kc3 Water Cooled Type , Type Of Lubrication – Greased Lubricated , Hammer Hanging Rod Diameter & Moc – 60 Mm (Ss-410) , Discs Must Be Fitted With (Ss-304 Bushes) , Drive Couplings–Cast Steel Geared Coupling Gc-109 At Both Ends , Nos Of Tightening Bolts – 10 Nos, Nos Of Teeth – 46 , Rotor Shaft Material 45 C8 Forged Steel With Ultrasonic Testing Of Bloom Shaft, Shaft Dia 350Mm Rotor Assembly Fitted With Domite Tips Of Size 90X90x60 Mm, Mtype Must Be Dynamically Balanced With Balancing Report. , Material Testing & Composition Report For All Assembly Part Is To Be Submitted At The Time Of Delivery , Note: - Old Anvil Plate, Discharge Chute And Deflection Plate Are To Be Used As Old And All Rest Material Will Be Used New, In Case Of The Swing Diameter Is Maintained 1875 Mm. , Scope Of Supplier :- Design, Approval Of Design & Drawing, Fabrication Of New Assembly As Per Technical Specification Given In Work Order, Dismantling Of Old Assembly At Mill Site, Modification In Foundation Or Bed, If Required, Erection & Commissioning Of New Fibrizer Assembly With Accessoseries And Satisfactory Load Trial At Mill Site.
