|
tender for special repair work on duhai to bhikkanpur bhadauli manauli revdi revda road - construction of embankment (for patri) with approved material obtained from borrow pits with a lift upto 1.5 m, transporting to site, spreading, grading to required slope and compacting to meet requirement of tables 300.1 and 300.2 with a lead upto 1000 m as per technical specification clause 301.5including cost of all material, labour, t&p & all taxes, cess etc. but excluding gst required for proper completion of work as per directed by engineer in charge. upto 1 km. cartedincluding all material, labour, t&p, taxes, cess etc. complete as per direction of engineer-in-charge but excluding gst. 2 providing, laying, spreading and compacting stone aggregates of 22.4-53 mm sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with threewheel 80-100 kn static roller in stages to proper grade and camber, applying and brooming, crushable screening to fill-up the interstices of coarse aggregate, watering and compacting to the required density grading 3 as per technical specification clause 405.including cost of all material, labour, t&p & all taxes, cess etc. but excluding gst required for proper completion of work as per directed by engineer in charge. 3 providing and applying tack coat with bitumen vg-10 grade using bitumen pressure distributor at the rate of 0.25 kg per sqm on the prepared bituminous/granular surface cleaned with mechanical broom. including all material, labour, t&p, taxes, cess etc. complete as per direction of engineer-in-charge but excluding gst. 4 providing, laying and rolling of open-graded premix carpet of 20 mm thickness composed of 13.2 mm to 5.6 mm aggregates either using penetration grade bitumen or emulsion to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable plant, laying and rolling with a three wheel 80-100 kn static roller capacity, finished to required level and grades to be followed by seal coat oftype-c as per technical specification clause 508.including all material, labour, t&p, taxes, cess etc. complete as per direction of engineer-in-charge but excluding gst. 5 providing and laying seal coat by manual means with vg-10 grade bitumen sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using type c as per technical specification clause 510including all material, labour, t&p, taxes, cess etc. complete as per direction of engineer-in-charge but excluding gst. 6 construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per clause 1501.2.2m 30(grade), coarse and fine aggregates conforming to is:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and construction joints, applying debonding strips, primer, sealant,near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,using curing compound (where specified) and water finishing to lines and grade as per drawing and finished with power trowel cum floter-trimix flooring machine.technical specification clause 1501.including all material, labour, t&p, taxes, cess etc. complete as per direction of engineer-in-charge but excluding gst.
|