|
tender for repair to stone jafri wall paver tile interlocking and fencing in tech area at afs jaisalmer; 1 demolition of concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) etc complete all as specified. 2 excavation in trenches not exceeding 1.50 meter wide or not exceeding 10 square meters in plan area and not exceeding 1.50 meter in depth for foundation in soft disintegrated rock soil and getting out etc complete all as specified. 3 m&l 75mm thick pcc 1:4:8 type d2 (using 40mm graded stone aggregate) as sub base. 4 m&l for precast cement concrete (1:3:6) type c1 (20mm graded stone aggregate) solid block masonary exc 10 cm in width and set in cm (1:6) including demolition 5 removing excavated material n. exc. 50 cm and depositing where directed at a level n.exc 1.5m above the starting point 6 providing and laying 80mm thick factory made chamfered edge cement concrete paver block of m-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using pu mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, fillingthe joints with fine sand and cutting ofpaver block as per required size andpattern, finishing and sweeping extra sand; complete including demolition in repair. 7 m & l for rubber moulded chequered cement concrete tiles 30cm x 30cm x 25mm thick,set in 1:6 screed bed 15 mm thick , jointed and pointed in neatcement slurry in floors with grey cement and pigments including demolition in repair. 8 m&l for heavy duty vetrified parking/ industrial tiles size upto 0.36 sqm each tile of thickness 10-12 mm of any type of colour and finish as approved in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match over 15 mm thk screed bedin cm 1:6 etc complete all as specified, including demolition in repair. 9 s&f in repair jaisalmer yellow sand stone jallies carved as per drawing,40-50mmthick laidfix with grouting mortar chemical with on top of wall base stoneincluding stone pillars all as specified and directed by engr -in - charge including base stone of thickness 75mm to 80 mm yellow stone for gouting of jalli over wall complete as photograph attached in tender document. 10 m&l in repair for 10-15mm thick jaisalmer stone cladding polished (machine cut stone of size exceeding 0.25 sqm fixed with) fixed with chemical metal lugs over 15mm thick backing coat in cm 1:4 complete all as specified and directed as photograph attached in tender document. 11 m&l in repair for 40 to 50 mm thk thick jaisalmer stone patties with engraved pattern as per drawing 150mm wide fixed in stone pillars including all direction as specified and directed by engr-in-charge and as photograph attached.(stone pillar to be paid seprately) 12 m&l in repair for jaisalmer stone pillars sqare in c/s of 90-100 mm thik thick with engraved pattern as per drawing for fixing of stone patties in item 11 above all as specified and directed by engr-in-charge and as photograph attached in tender document. 13 dismantling floor, hearth or wall tiling/granite including cement mortar bedding (but not backing) removing, serviceable tiles to stone and rubbish off the premises all as specified and directed. 14 m&l for 20mm thick granite ( of any type) slabs/tiles laid in floors/treads over 15mm thick screed bed in cm (1:6), set and jointed in neat cement slurry and pointed in white cement with admixture of pigment to match the shade of granite all as specified and directed. 15 ditto all as above but in skirtings/risers with 10 mm thick backing coat in cm (1:4). 16 demolition of brick work, stone/boulder or block masonry, built in cement mortar excluding ashlars facing dressed stone work and pre-cast concrete etc complete all as specified. 17 m&l for square rubble walling jodhpur type brought up to courses well bonded, bedded and solidly hearted in cement mortar 1:6 etc complete all as specified. 18 -ditto- as per sl item no. 17 but except stone. 19 taking down cement plaster of any description built in cement mortor complete all as specified 20 m&l for 15mm thick rendering in cm 1:4 on stone / concrete block masonry surfaces other than fair faces ofconcrete / brickis to be finished even and smooth(without using extra lime or cement) complete all as specified. 21 m&l for rendering 10mm thick on stone / concrete block masonry surfaces of any description in cement mortar (1:6) is to be finished even and smooth (without using extra lime or cement) complete all as specified and directed. 22 m&l 5mm thick rendering on concrete surfaces of ceiling,soffits of chajjas/drop & roof projection facia etc.in cm 1:3 finished even and smooth with out using extra cement complete all as specified. 23 m&l for dubbing out in cm 1:4 average 10mm thick on irregular face of walls/ceiling complete all as specified and directed. 24 m&l for preparation of newly plastered of wall surfaces and applying two coats of cement based paint over a coat of cement primer in different tints in sigma / camouflaging pattern as approved complete all as specified. 25 m&l for prepration of new surface plastered or unplastered applying three coats of white washing on ceiling,soffits of chajjas/drop & roof projection facia etccomplete as specified. 26 m&l for preparation of newly plastered of wall surfaces and applying two coat of oil emulsion distemper over a coat of cement primer in different tints in sigma / camouflaging pattern as approved complete all as specified. 27 m&l for preparation of old decorated wall surfaces of any description and applying one coat of oil emulsion distemper of any tint etc complete complete all as specified and directed by engr-in-charge. 28 m&l for preparation of old treated/ decorated external wall/roof surfaces of any storeys / height upto 10m of any description and applying one coat of cement based paint in different tints/shades in sigma/ camouflaging pattern as approved complete all as specified & as directed. 29 dismantling posts or struts (wood, steel or r.c.c.) embedded in concrete,brick work,masonary etc. any section, including taking out embedded portion and making good disturbed ground 30 dismantling fencing wire mesh, any type 31 m&l for pcc 1:3:6 type d-2 using 20 mm graded aggregate as in foundaton, filling and mass concrete , coping, edging , sloping etc complete all as specified and directed. 32 excavation in post holes (or similar) each n.exc 0.5 cum, getting out in any type of soil complete all as specified . 33 m&l cement concrete in foundation filling and massconcrete1:2:4 type b-2(using 40mm graded agg) all as specified. 34 m&l hand rails, half round or other stock section or core for wooden hand rail straight portion and curved or ramped portions of hand rails to required shape or figure (curved, ramped or scroll portions only measured), drilled and countersunk for balusters, nosing to steps incl embedding in concrete and screwing etc, wind ties for roof incl securing bolts: post and struts in fencing incl cutting topes to shape as directed, drilling holes, notching for wire etc, flat iron fillets incl all necessary drilling bolting or riveting etc, and similar work conf to fe 290 grade e-165 complete all as specified and directed. 35 supply only chain link fencing of oblong wire mesh size 100x100mm with weight n.exc 4kg/sqm complete all as specified and directed. 36 fixing only chain link fencing incl line wires, an mesh, size and type to any type of standards, rails, strain in bolts etc incl provision of binding wire andd fixing with ms angle iron fencing posts complete all as specified and directed. 37 preparation of new steel and iron surfaces of any description, not otherwise described, over 10cm in width or girth and applying two coats of synthetic enamel paint over a red oxide zinc chrome primer complete all as specified and directed. 38 preparing old steel surfaces and applying one coats of synthetic enamel paint etc all as specified and directed. 39 s&f in repairs galvanised 2 strand , steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and straining and fixing to any type of standard rails straining bolts incl securing or tying at crossing with and provision of galvanised mild steel wire staples or steel pins etc as directed(each line wire to be measured) complete all as specified and directed. 40 supply only 10mm ms round or square bars, as in horizontal line wire/bar in available lengths, complete all as specified and as directed.
|